View
7
Download
0
Category
Preview:
Citation preview
Technical specifications :Power supply: 230VAC±10%Distribution board fuse: max 13A
oOp. temperature: 0-40 CoStorage temperature: 0-50 C
Output voltage: 24Vdc ±2% 2.4W
Enclosure: IP 20 (LSBOX85)Dimension: 85 x 85 x 35mmHumidity: 10 - 90%RH
Output: 10 VDC, 5mA, impedance ~100ohm24 VDC, 100mA, 2.4W.
Relay output: 250 VAC 10A24 VDC 10A
Input, mains supply: 230VAC, 1.6A fuseInput, CO2: 0-10VDC, impedance 10KohmInput, POT: 0-10VDC, impedance >1Mohm
Min. 4700 ohm
Description:24VDC power supply from 230VAC mains supply via SMPS power supply.The power supply is intended for use with e.g. the ES 899 CO2 sensor, but it is also suitable for use with other products.
Furthermore the unit is able to compare the voltage on a 0-10V input with the potentiometer setting on the printed circuit board. If the input voltage exceeds the potentiometer setting the relay opens. It is also possible to connect an external potentiometer or a 0-10V signal instead of the internal potentiometer.
Mounting:The product is to be mounted on a firm base in a non condensing environment.
PowerSupply 0.1-24 E Power supply 24V / 100mA w/set point relay
Configuration:The threshold is set by adjusting the set point trimmer between minimum (0V) and maximum (10V).
JP1 must be removed if an external potentiometer or a 0-10V input signal are used.
lsc@lscontrol.dk tel. +45 5550 5550 fax +45 5550 2265
Drawing: 950-205350_PSU_CO2_ES963_UKRev.: 1.1Date: 06/06-2012Drawn by: KMManufactured by: LS Control A/S
T1.6
A
L
N
CO
MN
C
NO
GN
D
GN
D
GN
D
+24V
DC
0-1
0V
i IN
PU
T+
10V
DC
out
0-1
0V
IN
PU
T
Set point
MIN MAX
JP1
A BSkæ
rm
0 + +00 +T
~
ES 899
Jumper mounting:To be placed in position 0-10VSee ES 899 manual
+24V
DC
GN
DC
o2 Input
GN
D
Example of connectionto ES 899
5V
10V0V
Potentiometerset point adjustmen
PowerSupply 0.1-24E1.6
A
MAXMIN
Recommended