Pegboard Toy

Pegboard ToyAssembly and Sides

Assembly

• Please open up a “Standard.iam” file and place these objects in your window

Feeling Frustrated?• It will happen at some point or another, but don’t

give up. Feeling frustrated is all a part of learning.

Assembly• PLACE the pegboard and

pegs into an assembly window (.iam)

Constrain• Use the constrain feature to

connect parts of your assembly.

Constrain Round Peg• Constrain the axis of both

the peg and the hole in the pegboard.

Constrain Square Peg• For the square peg, you must

constrain 2 adjacent sides.

Constrain Square Peg• For the square peg, you must

constrain 2 adjacent sides.

Constrain Square Peg• For the square peg, you must

constrain 2 adjacent sides.

Next…• We need to put ends on our

Pegboard.

Sides!

End to your pegboard

1.Draw2.Extrude3.Save

.75” wide

.375” cut out

3 “Clicks” before you draw…

1. Click on the side you want to work on.

2. Click on “Create 2D sketch”

3. Click on the same side as you did in #1

1. Click on the side you want to work on

2. Click on “Create 2D sketch”

3. Click back on the long edge on the

pegboard

Your pegboard will look like this…

OK…Remember

this?

Draw an End Piece• Use the line

tool to draw around the end of the pegboard.

Finish Sketch and Extrude

• Extrude the end 3” – the same as the width of the pegboard.

RETURN!

Work Planes…• In the browser, right click on the

“WORK PLANE” button, and uncheck the visibility.

Other End…• “PLACE” the other end on the

screen, and constrain it into place.

Viola! Finished!?!

• Now you have a wonderful

pegboard toy!