Jewelry box By: Byran Tavon Lee PLTW Mr. Yates January 9, 2009

Jewelry box

By:

Byran Tavon Lee

PLTW

Mr. Yates

January 9, 2009

IntroductionIntroduction

The purpose of this particular project was to The purpose of this particular project was to challenge our engineering abilities to build a challenge our engineering abilities to build a presentable Jewelry Box.presentable Jewelry Box.

This jewelry box had to be made of 2 This jewelry box had to be made of 2 machinable wax with a dimension of 3 by 2 machinable wax with a dimension of 3 by 2 by.75. by.75.

This jewelry box first had to be designed on This jewelry box first had to be designed on inventor and transferred to EdgeCam to receive inventor and transferred to EdgeCam to receive its G&M codes.its G&M codes.

Finally we used the G&M codes to cut the block Finally we used the G&M codes to cut the block out on the CNC machine.out on the CNC machine.

Jewelry Box TopJewelry Box TopProjected ViewProjected View

Jewelry Box BottomJewelry Box BottomProjected ViewProjected View

EdgeCamTop

EdgeCamBottom

CNC Base Top

CNC BaseBottom

Top and Bottom

Conclusion With this project I learned how to use inventor and

EdgeCam together to design different things.

My project didn’t really solve the problem presented. I say this because my project wasn’t that good looking.

The one thing I done well on this project was my design on inventor. The one thing I could have done better was with the EgdeCam process.

The one thing I would do different with this project is my design.