View
219
Download
0
Category
Preview:
Citation preview
8/16/2019 Inventorium - Crete Sneaker
http://slidepdf.com/reader/full/inventorium-crete-sneaker 1/7
1
Crete Sneaker
Pattern by Alana Harley
Materials:
MC – Upper -1 ¾ oz (50g) of worsted
weight - BLUE
CC1 – Sole – 1 ¾ oz (50g) of worsted
weight - BROWN
CC2 –Bottom Trim + laces – small
amount of worsted weight -WHITE
Crochet hook 3.5mm (E) or size
needed to obtain gauge
Yarn needle
Gauge:
width 16hdc = 4” (10cm)
height 10.5 rows of hdc = 4” (10cm)
Stitches used
Ch = chain stitch St/s = Stitch/es
sc = single crochet
dc = double crochet
hdc = half double crochet
slst = slip stitch
sk = skip
FLO = perform stitch in front loop
only.
BLO = perform stitch in back looponly.
rep............repeat
beg..............beginning
[].................work instructions within
brackets as many times as directed.
(eg [2hdc, hdc] rep 3 times means you
repeat the brackets 2 more times, so
you have performed the bracket
instructions 3 times in total).
2tog….. work the two stitches
together (decrease) as directed.
MC = Main color
CC = Contrast color
Invisible slip stiches
This method gives a professional finish to
your items. Rather than joining with a
typical slip stitch, cut yarn and thread yarn
end through your needle. Insert the needle
under the top two loops of stitch you wish
to join to....
...pull through, then insert needle back into
the original stitch. Sew in ends.
Use normal slst’s to join all rounds unless
instructed to finish with an invisible slst.
8/16/2019 Inventorium - Crete Sneaker
http://slidepdf.com/reader/full/inventorium-crete-sneaker 2/7
2
For Beginners..
For sc rounds, the first sc is always worked
into the same st as ch1.
For hdc and dc rounds the beg ch2/3 counts
as a st, and the first st of the round should be
worked into the next st (unless told
otherwise).
When instructed to join to ch2, join at the
orange arrow, when instructed to join to the
1st hdc, join to blue arrow.
Size 3-6mos
4
10cm) finished length
On the first round it changes back and forth from sc to hdc – so pay attention!
Sole
Round 1. With CC1, ch11, 2sc in 2nd ch from
hook, hdc 8, 6hdc in last, hdc 8, 2sc in last.
Join to top 1st sc with a slst (26sts).
Round 2. Ch2, (count as 1hdc) hdc in same st
as beg ch2, 2hdc in next st, hdc 9, 2hdc in
each of the next 5 sts, hdc 9, 2hdc into last st, join to beg ch2 with a slst (34sts).
Round 3. Ch2 (count as 1hdc), 2hdc in 1st hdc,
hdc, 2hdc, hdc 10, [2hdc, hdc] rep 5 times, hdc
9, 2hdc in last st, join to beg ch2 with an
invisible slst , finish off and sew in ends
(42sts). Make two in soles CC1.
Round 4. Assemble the 2 soles with the
wrong sides together. Using CC1 slst 41
around the outside to join the 2 solestogether, (it may help if you begin between
the 2hdc in the centre of the heel), invisible
slst to join, sew in ends (42slsts – the join
counts as a st).
Upper
Round 5. Attach CC1 yarn (same color as
sole) in the back loop at the centre of the
heel.
Ch2 (count as 1hdc) and hdcBLO into each of
the next 16sts, dcBLO in each of the next 8 sts,
hdcBLO 17, join to beg ch2 with a slst (42sts)
finish off and sew in ends.
Join MC at the centre of the heel (I joined to
the top of the ch2 from the previous row).
8/16/2019 Inventorium - Crete Sneaker
http://slidepdf.com/reader/full/inventorium-crete-sneaker 3/7
8/16/2019 Inventorium - Crete Sneaker
http://slidepdf.com/reader/full/inventorium-crete-sneaker 4/7
4
Tongue.
Locate the central dc at tongue space (arrow).
Count out to the right 5sts, and join CC1 in the
5th st.
Row 1. Ch1, then sc2tog (with the first part of
sc2tog being worked in the same st as ch1), sc
in each of the next 5sts, sc2tog (7sts)
Row 2. Ch2, (count as 1hdc) turn, hdc in same
st as ch2, hdc in each of the next 6sts (8sts)
Row 3. Ch1, turn, sc in same st as ch1, sc in
each of next 6 sts (7sts) Fasten off and sew in
ends.
Top Trim
Join CC1 to the left hand side of shoe and slst
around the top of the shoe, right around to
where the tongue joins the shoe on the
opposite side. Finish off and sew in ends.
Laces
Using CC2, make one ch6 and one ch7, leaving
long tails on both ends to sew on. Sew the ch7across the top of the shoe, and the ch6 just
below it. Sew in all ends.
Make other shoe!
See notes at the end for a wee tip to keep
shoes on feet!
8/16/2019 Inventorium - Crete Sneaker
http://slidepdf.com/reader/full/inventorium-crete-sneaker 5/7
5
Size 6-12mos
4.5
11.5cm) finished length
On the first round it changes back and forth
from sc to hdc – so pay attention!
Sole
Round 1. Using CC1, ch13, 2sc in 2nd ch from
hook, hdc 10, 6hdc in last, hdc 10, 2sc in last.
Join to top of 1st sc (30sts).
Round 2. Ch2, (count as 1hdc) hdc in same st
as ch2, 2hdc in next, hdc 11, 2hdc in each of
the next 5 sts, hdc 11, 2hdc in last st, join to
beg ch2 with a slst (38sts).
Round 3. Ch2 (count as 1hdc), 2hdc in 1st hdc,
hdc in next, 2hdc in next, hdc 12, [2hdc, hdc]
rep 5 times, hdc 11, 2hdc in next, join to beg
ch2 with a slst, finish off and sew in ends
(46sts). Make two soles in CC1
Round 4. Assemble the 2 soles with the
wrong sides together. Using CC1 slst 45
around the outside to join the 2 soles
together, invisible join, sew in ends (46 slst-
the join counts as a st).
Upper
Round 5. Attach CC1 yarn (same color as
sole) in the back loop at the centre of the
heel. Ch2 (count as 1hdc) and hdcBLO into
each of the next 18sts, dcBLO in each of the
next 8 sts, hdcBLO 19, join to beg ch2 with a
slst (46sts). Fasten off and sew in ends..
Join MC where you finished off (I joined to the
top of ch2 from previous round).
Round 6. Ch1, sc 18 (remembering that 1st sc
is worked in same st as ch1 – now and
throughout ), scBLO 10 times, sc 18, join to 1 st
sc with a slst (46sts)
8/16/2019 Inventorium - Crete Sneaker
http://slidepdf.com/reader/full/inventorium-crete-sneaker 6/7
8/16/2019 Inventorium - Crete Sneaker
http://slidepdf.com/reader/full/inventorium-crete-sneaker 7/7
7
Tongue.
Find central sc at tongue space.
Row 1. Count out to the right 5 sts, and join
CC1 in the 5th st. Ch1, then sc2tog (with the
first part of the sc2tog worked in the same st
as ch1), sc in each of the next 5 sts, sc2tog
(7sts)
Row 2. Ch2, (count as 1hdc) turn, hdc in same
st as ch2, hdc in each of the next 6 sts (8sts)
Row 3. Repeat row 2.
Finish off and sew in ends.
Trim
Join CC1 to the left hand side of the tongue
and slst around the top of the shoe to the
opposite side where the tongue is joined,
finish off and sew in ends.
Laces
Using CC2 make one ch6 and one ch7, leaving
long ends on either side to sew on. Sew the
ch7 across the top of the shoe, and the ch6
just below it. Sew in all ends.
Tip
To help keep shoes on wriggly little feet I have
personally found elastic sewn around the heel
to be extremely useful. Sew a 1.25 inch long
piece of elastic (¼ inch width) around the
heel, keeping the elastic gently stretched, and
sew in ends.
COPYRIGHT This pattern is for your personal use only.
Please do not make copies for friends or family. This
pattern (including but not limited to images and text)
may not be distributed, reproduced, stored in or
introduced into a retrieval system, or transmitted, in any
form or by any means, (electronic, mechanical,
photocopying, recording or otherwise) without the prior
written consent of the copyright owner. Copyright
2014
Recommended