Install Instructions

Install InstructionsAugust 1, 2008

Standard Knock-out plates need to be removed from the

machine

You will receive a Template in your

User Manual for all Knock-out Plates

• For the four small holes – use a 7/32 drill bit• For the two larger holes – use a 3/8 drill bit

• Carefully drill holes on the appropriate Knock-out plate to the exact dimensions of our template.

• Reinstall Knock-out plate on the machine before adding Microtronic Msmart hardware.

Finished Product

This is what you receivein your Msmart Kit

Reader

Velcro

ReaderAntenna or Head

MDB Connector Cable

Cable from “Reader Head plug” to “Head”

Cable from “ANT” on Reader to plug on “Head”

Plug in detailsWhite plug from “Head” to “HEAD” port on Reader

Cable with Gold plug on both ends for “ANT” port on Head

MDB Cable will connect with Black end into “VMC” port on Reader

White MDB plugs go from the Vending Machine and Validator or Coin Mech

Before Installation• Make sure all power is turned off to the

Vending Machine• Have pre-drilled Knock-out Plate ready• You will need a Phillips Head

Screwdriver and an 11/32” Nut Driver• On National Vending machines you

may also need a ¼” Nut Driver for easier removal of the Knock-out Plate

Connection to the Vending Machine

Reader mounted with Velcro provided in kit

Make sure cables are not in the way by strapping them together.

Cables from Reader to Head

Predrilled Knock-out Plate installed

Head is mounted with 4 screws provided in kit

Green Light is “Ready to Go”

Vending Machines with Keypad• Press “Machine Config”• Arrow down to “Card Reader”• Select “MDB CARD”• Arrow down to “Revalue”• Select “ON” if you want the

machine to also Load Value to the Microtronic Media or “OFF” if not.

• Press “Exit”• You should then have a

“Green” light and you are again . . .

• READY TO GO!