ICAA Conferenceicaa-conference.net/ICAA6/Aluminium Alloys Volume 3/1447... · 2016. 6. 30. ·...

Preview:

Click to see full reader

Citation preview

Recommended

Electrical Resistivity and Strength of Cold Rolled Sheets ...icaa-conference.net › ICAA12 › pdf › 3B-18.pdf · Herewith, cold–rolled sheets of alloy 64Zr produced by Scheme
Documents
ICAA Conferencesicaa-conference.net/ICAA6/Aluminium Alloys Volume 2/923-929.pdfflow stress under these conditions was 6.7 MPa. The maximum of strain rate sensitivity was 0.38 for a
Documents
Deformation Behavior in Three-point Bending of Aluminum Alloy …icaa-conference.net/ICAA12/pdf/2C-18.pdf · 2016-06-02 · Deformation Behavior in Three-point Bending of Aluminum
Documents
Application of the Diagrams of Phase Transformations during …icaa-conference.net/ICAA12/pdf/P066.pdf · 2016-06-02 · The time-temperature region of the existence of the Ω'phase
Documents
Gate microstructure in an AlSi9MgMn High-Pressure …icaa-conference.net/ICAA12/pdf/2D-18.pdfGate microstructure in an AlSi9MgMn High-Pressure Die Casting ... Die design in HPDC typically
Documents
Hydrogen Evolution during Fatigue Deformation in 6061 and ...icaa-conference.net/ICAA12/pdf/2A-14.pdf · occurrence of IGC increases with grain size independently of HE sensitivity,
Documents
Fatigue Mechanisms of Brazed Al-Mn Alloys Used in Heat ...icaa-conference.net/ICAA12/pdf/2A-11.pdf · Aluminium Alloys, September 5-9, ... Fatigue Mechanisms of Brazed Al-Mn Alloys
Documents
Trace Elements In Aluminium Alloys: Their Origin …icaa-conference.net/ICAA12/pdf/KL-10.pdfincluding laquering, anodising, coatings as well as non-aluminium contaminant in the Al-scrap
Documents
thick plate, V-bending, deduction, camber, A5083.icaa-conference.net/ICAA12/pdf/2C-17.pdf · of experiments in V-bending process by changing die-open width. As a result, it is quantitatively
Documents
ICAA Conferenceicaa-conference.net/ICAA6/Aluminium Alloys Volume 2/1209-1214.pdf · 1209 TEXTURE VARIATION AT HOT ROLLING GAUGE OF AAI 050 ALLOY AND ITS EFFECT ON EARING BEHAVIOUR
Documents
Development of High-strength Aluminum Extrusion Alloy for …icaa-conference.net/ICAA12/pdf/P085.pdf · 2016. 6. 2. · Proceedings of the 12th International Conference on Aluminium
Documents
A TEM Study on -Al(Mn,Fe)Si Dispersoids Precipitated in ...icaa-conference.net/ICAA12/pdf/2B-19.pdf · Yanjun Li1, Trond Furu2, Soren Kahl3, Arne Olsen4 1 SINTEF Materials and Chemistry,
Documents
Effects of Natural Aging and Cold Work on the Strength of 2013 …icaa-conference.net/ICAA12/pdf/3B-12.pdf · 2016-06-02 · Proceedings of the 12th International Conference on Aluminium
Documents
Effect of Cooling Method on the Microstructure and ...icaa-conference.net/ICAA12/pdf/2B-16.pdfContent 7.67 1.69 1.75 0.12 0.026 0.013 0.0022 Balance 3. ... Specifically, the conductivity
Documents
Instability of Microstructure in Friction Stir Welded 5083 ...icaa-conference.net/ICAA12/pdf/P022.pdf · Since the shoulder gives a severe plastic deformation generating ... method
Documents
Microstructure and Mechanical Properties of Al -Mg-Si ...icaa-conference.net/ICAA12/pdf/P043.pdf · the microstructures of the thixoformed C3 alloy consisting of large (~185 m) and
Documents
Correlation between texture and formability of aluminum ...icaa-conference.net/ICAA12/pdf/IL-11.pdf · 2. Procedure of numerical computations 2.1 Modeling of textures In aluminum
Documents
Same Area Observations on Recrystallization in Cold-Rolled ...icaa-conference.net › ICAA12 › pdf › 1C-05.pdf · Keywords: Recrystallization, recovery, EBSD, Al-Mg-Si alloy,
Documents
Effect of Scandium on Mechanical Prop erties of …icaa-conference.net/ICAA12/pdf/2B-12.pdfThe results of grain refinement and modification eutectic silicon experiments are shown in
Documents
127-138icaa-conference.net/ICAA6/Aluminium Alloys Volume 1/127...Proceedings of1CAA-6 (1998) 3.2 Comparison with wrought aluminum alloy The relationship between fitigue crack propagation
Documents