go to click on Support & Drivers Steps to install printer...

● go to http://www.xerox.com● click on "Support & Drivers"

Steps to install printer driver for Xerox Phaser 6360 (Macintosh OSX 10.6 and up).

● in the "Search or choose" box enter "phaser 6360"● click on "Phaser 6360"

● click on "Drivers & Downloads"

● make sure that the correct operating system and language is selected● click on "Print Driver Installer for Max 10.6 through 10.8" to start

downloading the installer

● once the download is finished, click on the .dmg file to mount the installer and run it

● click on the "IP Address or DNS Name icon (third from left)● Enter the printer's DNS name (in this case "xrx0000aaa1d0d0.dhcp.mc.vanderbilt.edu"

for color4 the printer ● If the DNS name is entered correctly then information about the printer will appear● Click Continue

● Click Continue again

● To change the printer name, open System Preferences● Click on "Print & Scan"

● Double click on the printer just installed● Click on the "Printer Setup" icon● Click on "Printer Setup"● Change the name to "color4"● Click "OK" and exit System Preferences