GCC StellarJet 250UV Demonstration Eric Huang March 14, 2006

GCC StellarJet 250UVDemonstration

Eric Huang

March 14, 2006

Introduction Flow

• Outlook

• Hardware

• Controller

• RIP

• Printing

Service StationService Station Printing AreaPrinting Area Work StationWork Station

Vacuuming Conveyer System

Extension Roller Table

Media Feed and Take-up Roller

** Work with X motor assembly for media movement

• Media Bar (Front & Rear)• Alignment Bar

• Foot Pedal (Front & Rear)

Rail System

** Work with Y motor assembly for print carriage movement

Print Carriage

• Print Head Module* CMYKLcLm: Xaar XJ500, 360dpi* W: Xaar XJ500, 180 dpi

• Sub Tank

• Head Board and Relay Board

Print Carriage• Auto Media Calibration (AMC™)

– Work with Z motor

UV Lamp Box and Power Supply

• UV Lamp Controller

(Power supply & counter)

Service Station

+/- Pressure System vs. Ink Supply

Positive Pressure Pump

Negative Pressure Pump

Compressor• Control media bar / alignment bar / service station

cover and wiper / cap and cover / media roller / UV Lamp Shutter

Board• Control I/O Board• X/Y-axis card,120 DIO card & PCI card (on IPC)• Carriage Board• Print Engine Board• Valve I/O Board

IPC

LCD Monitor (Firmware Controller)

RIP - ColorPRINT Server Pro (with ICC Profile)