View
223
Download
0
Category
Tags:
Preview:
Citation preview
G1 to G1b
LOW VOLTAGE
Schematicto
Pictorial
You will now draw the
Pictorial
by following the
Schematic
The process will be to follow the
schematic one wire at a time from one
component to another component until
you are finished.
The slides that follow will show the wire in RED on
the schematic that is going to be wired on the
pictorial. Then the pictorial slide will show that
wire being ‘installed.’ This is the wire you are to
place on your pictorial. Keep advancing through
this slide presentation until you are finished with
the pictorial.
Before you begin to wire any low voltage circuit, you need to identify the
low voltage ‘POWER’ side and ‘COMMON’ side of the transformer.
The ‘POWER’ side is ALWAYS the side that goes to the identified terminal
on the thermostat. In this diagram it is the ‘V’ terminal. This is for ITT,
which is no longer used. It will be the ‘R’ terminal instead of this ‘V.’ See
below where I have identified the ‘POWER’ side and the ‘COMMON’
side of the transformer. Now move onto the next slide and complete the
pictorial.
P C
Since there are two yellow wires, you need to
identify which one is ‘P’ and ‘C’ or you will
wire the unit incorrectly. It does not matter
which one is ‘P’ or ‘C.’ See below.
P
C
‘V’ of the terminal stripon the equipment.
‘V’ on the thermostat
P
C
You have finished the
LOW VOLTAGE
circuit.
The next slide shows your completed
PICTORIAL
and this is what you need to show
your Instructor for credit.
THEEND
Recommended