Ford Kuga AWD Programmable Module Installation Guide

Ford Kuga AWD Programmable Module Installation Guide

Model:

2008 Kuga

Operation:

Replace the AWD module and input data manually

Conditions and Requirements:

The communication is normal, and battery voltage stable

Software Version

Ford V48.50 or above

Product requirement

X431 PRO series, PAD series products.

Operation Steps:

1. Enter “Ford” software and choose “Auto Search”.

Illustration 1

Illustration 2

2. Confirm the vehicle specification, and choose “Yes”.

Illustration 3

3. Select “Module Programming”.

Illustration 4

4. Select “Programmable Module Installation”.

Illustration 5

5. Select “AWD(All Wheel Drive”.

Illustration6

6. Whether the original mode still available? If we have removed it, please select “No”.

Illustration 7

7. Read the tips carefully, select “manual” when we have replaced by a new module or

original module not available.

Illustration 8

8. Input the VIN code on Ford OEM website to query the original factory data, find the

corresponding section of ‘761-01-01’ and manually enter the data in turn (Illustration 9-1)

Illustration 9-1

Illustration9-2

Illustration9-3

Illustration 9-4

9. Set ignition switch to OFF (position 0).

Illustration 10

10. Input the VIN.

Illustration 11

11. Confirm the VIN right or not.

Illustration 12

12. Install a new module in vehicle.

Illustration 13

13. Turn on ignition.

Illustration 14

14. Wait, communicating…

Illustration 15

15. Succeeded.

Illustration 16