View
220
Download
1
Category
Preview:
Citation preview
7/30/2019 Feed Sack Tote Sewing Pattern PDF
1/3
GET SEWING!SM
with Barbara Edmondson
Feed Sack Tote
Recycle / Repurpose
Deer Corn, Pet Food, Ag Feed sacks
made of woven plastic in to useful,
sturdy, large totes!
Supplies needed:
An empty plastic feed sack, or pet food
sack
Polyester thread
A machine needle size 90/14 or 100/16
Helpful:
Acrylic template ruler, rotary cutter, and
self healing mat
Copyright March 2012 Barbara J. Campbell Edmondson, all rights reserved. Copying or distributing this pattern is NOT permitted.
Download patterns at www.getsewing.com
7/30/2019 Feed Sack Tote Sewing Pattern PDF
2/3
Instructions to make Feed Sack Tote:
Read ALL of the instructions before starting to sew, so
you will have a better understanding of it all.
I set my stitch length at 4, because I want to poke less holes in the fabric .
The plastic is stiffer than fabric so this project requires crunching the bag to work with it.
~ ~ ~ Now, Get Sewing! ~ ~ ~
1. Wash thoroughly the inside and outside of the emptysack.
2. Open both ends. Usually there is a string that will easilycome unstitched if you pull it just right. If not, you cut it off
however you can. Now you basically have a tube.
3. Lookat the designs on your bag and decide whatparts you want to try to keep, what places youre willing to
cut off to make handles or to become the bottom.
Things to consider:
You will need to cut off 3 4 inches around one end to
use to make the two handles.
Boxing the bottom of the tote will take 2-4 inches.
You may wish to cut off more of the bag than needed
for the handles and bottom.
4. After youve made your decision, cut a 3 4 inchesstrip around for the handles. You will be cutting through two
layers since its a tube. You can lay it flat on a self-healing
mat and use a rotary cutter and acrylic template ruler, or
you can measure & draw marks and use old scissors. Do not
use your good sewing scissors on this plastic, it could ruin
them!
5.Sewing Handles: While folding handle in half length-wise, rub a crease on the fold. Then turn in each long edge
in toward center crease and press creases. Then fold over
so that long cut edges are tucked into the first creased fold.
See Figure 5. You cant use pins, but you could binder clipsor clothes pins. Your handle now has 4 layers. Then, Stitch
closely along both long edges.
6.Turn the bag inside out by reaching inside, crunch andgrab the bottom and work with both hands to pull it
through. See photo 6. Then lay the bag flat.
. . . . . . . . . . Continue to next page
Copyright March 2012 Barbara J. Campbell Edmondson, all rights reserved. Copying or distributing this pattern is NOT permitted.
GET SEWING!SM Page 1 of 2www.getsewing.com Feed Sack Tote
(4.)
(5.)
Download more patterns at www.getsewing.com
(6.)
7/30/2019 Feed Sack Tote Sewing Pattern PDF
3/3
7. As shown in photo 7, Sew a seam across thebottom opening of the bag. I used about a inch
seam allowance.
Then overcast the edge, I used a regular
wide zig-zag stitch.
Do step 8 to both sides of the bottom.
8. Workwith the bag to line up one end of thebottom seam with the center of a side (not too
hard to find because its usually creased). Hold in
place.
Draw a line about 2 inches in from point/
corner. You can use a 45 degree angle on your
ruler to make it straight.
Sew along this line. This forms the box bottom
of the bag. See photo 8.
9. If desired - Fold the corner triangles toward
the bottom and attach the seam allowances of thecorner point end and the bag bottom seam by
sewing the seam allowances together a few
stitches. You can do this on the machine or by
hand.
10.Turn the bag right side out.
11.Measure & rub a crease, an inch (or whatyou choose) around the top edge of the bag.
Sew a seam along close to the cut edge.
12.Find the center of the front and back of thebag. I do this by folding in half & drawing a mark
with a pencil, see photo 11.
13.Measure & mark3 inches from each side ofthe center mark on front & back of bag. This is for
handle placement.
Sewing on handles
14.Referring to figure 13, Position a handle endat the outer edge of a mark, overlapping onto bagabout an inch. Hold in place.
15.Sew to attach handle securely. I sew asquare, then an X in it. Sew both handles on the
same way.
Copyright March 2012 Barbara J. Campbell Edmondson, all rights reserved. Copying or distributing this pattern is NOT permitted.
GET SEWING!SM Page 2 of 2www.getsewing.com Feed Sack Tote
(7.)
45
angle
(8.)
(12.)
Congratulations! You madeyour own Feed Sack Tote!
center
position handle en
to the outer edge of
the mark that is away
from the center
(13.)
Bagbottom
handle
Recommended