EOL TESTER INSPECCIONES DEL SISTEMA BalloonPartFunction 1 Control backplane It is the area where the...

EOL TESTER

INSPECCIONES DEL SISTEMA

Balloon Part Function

1Control

backplaneIt is the area where the electrical components for the equipment to operate

2 PCB’s load Apply loads with DC or GND to the UUT3 Enclosure Interface between UUT and PXI

4PCB's

communicationGenerate U-sonic, K-line and S-net communication with UUT

5 UPS

In the absence of energy, its function is to keep lit the critical parts of the system (PC and programmable fountains mainly) so they can be turned off normally.

6

PCB's of sicht for

communication channels

Switcher between communication channels UTT

Balloon Part Function

1 PXI ChassisInterfaces between instrumentation and acquisition system and PC.

2 PC Main system controller

3 DC sources Energize equipment parts for testing

4 Sources Sorensen Energize the UUT for testing

5 Electronic Load Applying a controlled load to the UUT

DIAGRAMA DE FLUJO

REALIZAR PRUEBA

PANTALLA PRINCIPAL