View
221
Download
1
Category
Preview:
Citation preview
1/3
F-117 interior S.A.
32 744
32 7441/32 scale detail set for kit • sada detailù pro model Trumpeter 1/32 Trumpeter
ORIGINAL KIT PARTSPÙVODNÍ DÍLY STAVEBNICE
PHOTO-ETCHED PARTSLEPTANÉ DÍLY
PARTS TO BE REMOVEDDÍLY K ODSTRANÌNÍ
FILLTMELIT
eduard
REMOVEODSTRANIT
OPTIONVOLBA?REPLACENAHRADIT
BENDOHNOUT
GRINDOBROUSIT
SYMETRICAL ASSEMBLYSYMETRICKÁ MONTÁŽ
DRILL HOLEVRTAT OTVOR
APPLY EXPRESS MASK AND PAINT BEFORE GLUINGPOUŽÍT EXPRESS MASK NABARVIT PRED SLEPENÍM
40
30
38
49
23
50
55
C41
F3, F4, F19
=
=
6
7
52
44
43
F13
49
26
3950
55
C41
F4, F19
=
16 21
511
12
8
3
14
13
4
19
2
1
1820
17
15
F14
=
FILM
© EDUARD M.A. 2012 www.eduard.com Made in Czech Republic
2/3 32 744
31
28 29
54
35
32
33
34
F7
=
10
9
F22
24
F2
25
22
18
F1
42 F9
F10
57
47
48
36 37
45 46
56
51
TOPFUSELAGE
53
53
eduardFor further detail sets look for 32 316 F-117 exterior(not included in this set)
eduardFor further detail sets look for 32315 F-117 bomb bay(not included in this set)
eduardFor further detail sets look for 32 754 F-117 seatbelts(not included in this set)
27
F11
41
41F21
film B
film A
F22
H10
H9
3/3 32 744
2. Do not inadvertently place etched componets on an unwanted surface. Attempts to remove will result in damage to your part.
2. Nepokládejte samolepící díly na volné plochy. Pokud je omylem pøilepíte, pøi pokusu o odlepení dojde k poškození dílu.
3. Do not touch the adhesive areas of the etched components.
3. Nesahejte na èásti dílù, na kterých je naneseno lepidlo.1. Separate the etched components from their frames on the protective paper. Removal from the paper is done only after separation of the parts from the frames.
1.Samolepící díly oddìlujte od rámeèku na podkladovém papíøe. Po oddìlení je sejmìte z krycího papíru.
4. Hold the parts by the edges, or at areas free of adhesive.
4. Samolepící díly berte za hrany nebo za èásti, na kterých není nanesené lepidlo.
5. Lightly place the component in the desired location and position. Adjust as required. The component will be permanently affixed when pressed onto its intended location, its location can be adjusted.
5. Díl lehce položte do pozice, ve které má být nalepen. Upravte pøesnou pozici a pøimáèknìte. Díl dokonale pøilne až po pøimáèknutí, pøed pøimáèknutím lze dílem opatrnì manipulovat.
PARTS WITH GLUE DÍLY OPATØENÉ LEPIDLEM
Recommended