Eaton Airflex - Gringing Mill Product

S

Eaton Airflex Products for Grinding Mills Mining – Cement

S

1.  VC Pneumatic Clutch 2.  VC Torque Limiting Couplings 3.  Inching Drives 4.  Electronic start and slip Clutch Control 5.  Rotorseal 6.  Tank Group System 7.  VC service parts and repair Kits 8.  VC Rebuilt parts

Eaton Airflex Products for Gringing Mills

S

Typical Drive with Clutch

Clutch Pinion

Ring Gear Mill Shell

Motor

Inching Drive

S

Airflex Dual VC Clutch

Pinion

Low Torque Synchronous Motor

Typical Drive with Clutch

S

650%

175%

250%

100%

Ampe

rage

Time Low-Torque Synchronous Motor Start

Clutch Engagement

High Torque Motor Start

Time to Start Mill with Either Drive

Low-Torque Synchronous

Motors Require Less Amperage & Power Per

Start

Mill Motor Current Demand

S

Release Springs and Torque Bars Ventilated

Design

Reinforced Rubber Tube

Heavy Duty Friction Shoes

VC Clutch Element

S

Torque Limiting Couplings

S

Inching Drive

Elector-Mechanical Up to 100HP Up to 30.000 Lb-ft

Low and High Power Hydraulic. 25 HP to 500 HP 20.000 to 1.000.000 Lb-ft

0 to 2 RPM

S

Slip Detection Control

Start, Slip and Continuous Clutch Control and performance

S

High Energy VC Clutch

•  High Torque •  Low Start Current •  Longer Start Time

S

Parts: Service and Repair Kits

-  Airtubes -  Friction Blocks -  Torque Bar – Sprigs -  Axial Locking Devices -  Side Plates -  Drums -  Rotorseals -  Kits

S

Eaton Airflex Customers:

And More….

S

Literature

TWO Years Warranty Coverage

Español

S

Grinding Mill Clutches and motion control systems

Specialist. Technical and Commercial Support for Mining and

Cement mills applications

Eng. German Estrada Kaizen@kaizen.com.co www.eatonkaizen.com Miami Office: Tel 5613864122