Convection Microwave Trim Kit Flush Mount Cabinet Width 7 8" Frame Depth 20 11 16" Minimum...

30"Cabinet Width

78 "

Frame Depth

201116 "

Minimum Depth

1918 "

CabinetOpening

1958 "

FrameHeight

729 8 "

Frame Width

PLANNING GUIDE TKCFP307

Convection Microwave Trim Kit Flush Mount

For replacement parts or if further help is needed concerning this appliance call:Toll Free 1 888 9 FNP USA (1 888 936 7872) or write to:

Fisher & Paykel Appliances Inc., 5900 Skylab Road, Huntington Beach, CA 92647or contact us through our web site: www.fisherpaykel.com

Minimum Depth

201116 "

FrameDepth

78 "

Distance from shelf to cutout

2116 "

Cutout Height

1578 " 1/8"

Cutout Width

251516 " 1/8"

Frame Width

2978 "

FrameHeight

1958 "

PLANNING GUIDE TKCFP307

Convection Microwave Trim Kit Surface Mount

For replacement parts or if further help is needed concerning this appliance call:Toll Free 1 888 9 FNP USA (1 888 936 7872) or write to:

Fisher & Paykel Appliances Inc., 5900 Skylab Road, Huntington Beach, CA 92647or contact us through our web site: www.fisherpaykel.com

Installation Instruction of Fan Box

for convection microwave trim kits

Important Information

1) After installing the runners, plug-in the 12VDC transformer

and place the cord along the right side of the cabinet.

2) Before peeling off the PVC coating from the stainless steel frame,

slide-in the Fan Box as shown in the image below. Plug-in the

12V supply and position the Fan Box approx. 1-1/2” to 2”-Inch set

back from the face of the microwave.

1-1/2” - 2”-Inch

(40mm - 50mm)

Fan Box

Microwave