Concept V2.5 Lesson 11 Objectives: After completing this lesson, the learner will be able to: ...

Concept V2.5

Lesson 11 Objectives:After completing this lesson, the learner will be

able to: Define the configuration rules associated with the

Quantum Controller. Perform the configuration using Concept software. Create an I/O map using the appropriate

configuration software. Establish special drop characteristics and I/O

module setup Connect to a Quantum controller. Download a configuration and I/O map to a

Quantum controller.

Concept V2.5

Concept V2.5

UserLogic

Concept V2.5

I/O Mapping to State RamState-RAM

DDI...

DDO...

AVI...

AVO...

3x

4x

HW

I/O Map Ranges

1x

0x

1:1 - 1:32

0:1 - 0:32

3:1 - 3:8

4:1 - 4:4

1:1

0:1

3:1

4:1

FieldDevices

Concept V2.5 I/O Map Overview Screen

Concept V2.5

Concept V2.5 Select the required Module

Concept V2.5

Module Addressing

Concept V2.5

Module Parameters

Concept V2.5

Module Parameters (Analog Input Module)Select required ranges

Concept V2.5

Module Parameters Help Screen

Concept V2.5

Module Parameters (Analog Output Module)Select required output behavior on Timeout

Concept V2.5

Module Parameters (Discrete Output Module)Enter required output behavior on Timeout

Concept V2.5

Connecting to a Quantum PLC

Concept V2.5

Download and Start a Program

Concept V2.5

PLC Simulation Two PLC simulators

Used for online testing of the IEC user program (FBD, SFC, LD, IL, and ST) without any hardware.

SIM (16 Bit) Simulates a Quantum PLC connected via Modbus Plus. This simulator is available under Windows 3.1, Windows for

Workgroups 3.11, Windows 95 and Windows NT. Concept PLCSIM32 (32 Bit)

Simulates a PLC connected via TCP/IP, includes simulation of signal states in I/O modules.

Up to 5 programming units can be connected to the simulated Quantum at the same time (via a TCP/IP Ethernet connection).

This simulator is only available under Windows 95/98 and Windows NT.

Concept V2.5

The 16 Bit Simulator File Location

Concept V2.5

The 32 Bit Simulator File Location

Concept V2.5 The 16 Bit Simulator

Starting the 32 Bit Simulator

Simulators

Concept V2.5

32 Bit Simulator Initial Quantum StartupNothing in Memory

Select CPU Type

Concept V2.5

Connect to IEC Simulator(32 Bit) From IEC Simulator: Select required CPU type Download configuration and program

Select CPU Type

Left Mouse Button:Select 16 bit input group

Left Mouse Button:Select 16 bit output group

Left Mouse Button:Select register address

Right Mouse Button:Select value range, format

CPU Status

Left Mouse Button:Change values ofInput, Output,Register addresses

Concept V2.5

Components of PLCSIM32

Right Mouse Button:Change format

Left Mouse Button:Change values

Concept V2.5

More Components of PLCSIM32