Comm Operator Tutorial How to send sequence data at given time automatically Serial Port Tool

Preview:

Citation preview

Comm Operator TutorialComm Operator Tutorial

How to send sequence data at How to send sequence data at given time automaticallygiven time automatically

Serial Port Toolhttp://www.serialporttool.com

Comm Operator Tutorial

TaskTask

Send sequence data at given time automatically.Send sequence data at given time automatically.

Sample: Turn on Relay 1-3 at 9:50

Turn off Relay 1-3 at 9:55

Comm Operator Tutorial

Step 1. Open Comm OperatorStep 1. Open Comm Operator

Comm Operator Tutorial

Click to open Auto Send Rule Setting dialog

Step 2. OpenStep 2. Open Auto Send Rule SettingAuto Send Rule Setting dialog.dialog.

Comm Operator Tutorial

Click to show Select Rule Type dialog

Step 3. Select rule type and open Step 3. Select rule type and open Group Data RuleGroup Data Rule dialog.dialog.

Click to open Group Data Rule dialog

Comm Operator Tutorial

Step 4. Set condition of Step 4. Set condition of Start EventStart Event. .

Click to open Event Editor dialog

Click to return Group Data Rule dialog

Comm Operator Tutorial

Step 5. Set condition of Step 5. Set condition of Step EventStep Event..

Click to open Event Editor dialog

Click to return Group

Data Rule dialog

Comm Operator Tutorial

Step 6. Edit send data.Step 6. Edit send data.

Click to open Data Editor dialog

Click to return Group Data Rule dialog

Click to add other data

Click to return Auto Send

Rule Setting dialog

Comm Operator Tutorial

Step 6. Edit send data.Step 6. Edit send data.

Click to add another group data rule

New rule name

Click to return Auto Send

Rule Setting dialog

Comm Operator Tutorial

Step 7. Finish setting for auto send rule.Step 7. Finish setting for auto send rule.

Click to finish setting and return Main GUI

Comm Operator Tutorial

Step 8. Open port. Step 8. Open port. Make sure the port connected with the device.Make sure the port connected with the device.

Click to show Open Port dialog

Click to show Select Link Type dialog

Click to select link type Click to open port

Comm Operator Tutorial

Step 9. Run the auto send rule.Step 9. Run the auto send rule.

Click to start auto send

Auto Send ResultTurn on Relay 1-3 at 9:50Turn off Relay 1-3 at 9:55

Recommended