Cable Probe. Safety First System can conduct electricity Do not use in flammable atmosphere Use...

Cable Probe

Safety First

• System can conduct electricity

• Do not use in flammable atmosphere

• Use proper personal protective equipment

Do not move probe head by

hand

General Precautions

The system is not waterproof

General Precautions

• Do not kink the cables into loops smaller than 10 inches in diameter

• Do not carry the unit by the cable

• Do not step on the cables or connectors

General Precautions

• Do not use the cable reel as an anchoring point for the Cable Probe during rescue operations

System Set-Up

• Mount video display onto probe using sliding collar

• Line up display plunger key on display with internal keyway on control console

System Set-Up

• Connect video display by lining up red dot on display cable to red dot on 7-pin connector on rear of control console

• Slide connector barrel back and insert into console

System Set-Up

• Connect headphone cable to bottom left connector on rear of console

• Slide connector barrel back and insert into console

System Set-Up

• Connect battery cable to battery

• Align connectors to slots for easy connection

System Set-Up

• Connect Cable Probe to 16-pin connector

• Align connectors to slots for easy connection

System Set-Up

• Connect shoulder strap located on front of probe and on rear of console, if desired

System Set-Up

• Attach display hood for enhanced visibility in bright sunlight

System Operation

Cable Probe

Powering Up

• Depress the power switch on the bottom of the console grip until the system powers up

Camera Head Articulation

• Depress the top rocker switch on the console grip to the left or right to move the camera head left or right

Illumination

• Depress the switch on the console grip marked by the illumination symbol to activate the lights on the end of the probe

Display Brightness/Contrast

• Controls on top of video display

• Depress and hold control button to cycle through settings

Camera Orientation

• Camera head can be rotated to adjust for different viewing orientation

• Rotate camera head to corresponding silver dots on probe as required

Auxiliary Multi-port

• Additional 7-pin connector can provide data and video

• Use of a standard video recording device is possible for training and review with optional adaptor

Audio / Intercom

• Control search audio volume by control button on console grip

• Push-To-Talk feature activated by control button on console grip

Audio / Intercom

• Headphone volume control located on side of headphone earmuff

System Maintenance

Cable Probe

Battery Care

• Fast cycle charges battery to 90% capacity in about 2 hours

• Slow trickle charge completed in 3 additional hours

• Battery is heavy. Handle with care

Probe Maintenance

• Periodic tightening of screws as necessary

• Do not over-tighten screws

Clean Video Display

• Blow dust off screen with compressed air

• Clean the screen with glass cleaner

• Spray cleaner onto cloth first, NEVER onto the screen

Clean System

• Blow dust off probe with compressed air

• Wipe off with clean cloth

Clean System

• Wipe down cables with clean cloth

• Apply thin application of rubber preservative

Inspect System

• Connect all components and test system

• Start visual inspection by confirming protective cover over lens is clean and in place

Inspect System

• Inspect articulating joint rubber boot for tears or damage

Inspect System

• Inspect control switches for function and condition

Inspect System

• Inspect cables and connectors for damage

System Packing

Cable Probe

System Packing

• After inspection, pack system into protective case

• Ensure that cables are secured and camera head is centered

• Store indoors

Search Systems, Inc. PO Box 80307 Bakersfield, CA 93380 1-800-722-2824 1-661-588-6270www.searchsystems.com

Cable Probe