View
236
Download
2
Category
Preview:
Citation preview
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 1/13
AE 416
APPLIED AERODYNAMICS
FALL 2014
HW#8
CARLOS ALBERTO NUNES DA SILVA JR.
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 2/13
1)
Analyze the following case:
AR = 4, 10, 16 (sweep)
λ = ct/co = 1
Λ = 0 degα = 10 deg
(a) What is the MAC and speed for each case to match the required Reynolds number?
The MAC is given by the following equation, where is the root chord.
22 1
3 1r
c c
(1.1)
The Re number is calculated based on the CMA and the freestream velocity as follows:
Re V c
(1.2)
Since Re number and (assumed sea level conditions) are fixed, we can solve the equation
1.2 for V and find the wing speed to match the Re.
To calculate lift curve slope for each wing we just divide the variation of CL by the
corresponding angle of attack change:
L
L
C C
(1.3)
The angle of attack in the simulations of this homework is 10 deg, and all the wings airfoil are
symmetrical ( = 0 = 0 ) so the lift curve slope is just the wing CL divided by .
To calculate the wing efficiency we just divide the CL by the 2D airfoil lift coefficient:
L
l
C e
C (1.4)
The for the airfoil e168 at 10 deg of angle of attack is equals to 1.12.
Since the aspect ratio and the tapered ratio are defined, we can set only the = 3.28 and
then the span and tip chord will be calculated; once all the wings have the same root and tip
chord (only for question 1) then the MAC and the wing velocity will not change with the AR,
as we can see in the figure below:
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 3/13
(b) Co-plot the spanwise lift coefficient distributions.
(c) Co-plot the downwash distributions.
(d) Co-plot the wing planforms.
0
0.2
0.4
0.6
0.8
1
1.2
-30 -20 -10 0 10 20 30
C
L
Wing Span [ft]
CL distributionsAR = 4AR = 10AR = 16
-50
-45
-40
-35
-30
-25
-20
-15
-10
-5
0
-30 -20 -10 0 10 20 30
D o w n w a s h [ f t / s ]
Wing Span [ft]
Downwash distributions AR = 4AR = 10AR = 16
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 4/13
(e) Tabulate the wing lift coefficients CL.
(f) Discuss the eff ect of aspect ratio on the Cl distribution.
The results shows that the wing CL is directly proportional to the AR. In the wings with high
aspect ratio the induced velocities due the tip vortices are smaller when compared with a low
AR wing therefore the induced angle of attack does not decrease too much, and then the CL is
similar to the 2D the airfoil CL. In the figure for CL distribution we can see that in the center
of the wing with aspect ratio of 16 the lift coefficient (1.04) is very similar to the airfoil CL
(1.09).
(g) Discuss the eff ect of aspect ratio on the downwash distribution.
The downwash distribution along the wing is inversely proportional with the distance of the
section to the wing tip vortices squared. In the simulations performed all the wings have the
same root and tip chord, so the wingspan changed in order to satisfy the aspect ratio desired
(the wingspan increased with the aspect ratio), therefore a high AR wing has the lower
downwash.
(h) Discuss the eff ect of aspect ratio on CL.
-6
-4
-2
0
2
4
6
8
10
12
14
-10 -5 0 5 10
Wing Span [ft]
Wing planform
AR = 4
AR = 10
AR = 16
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 5/13
Since the wing section CL increases with the AR the overall CL will present the same behavior.
If the aspect ratio becomes large the wing CL get closer to the airfoil 2D viscid lift coefficient.
(i) Calculate the lift curve slope of each wing and determine the wing efficiency e.
Show your work and discuss (as compared to each other and the elliptical case).
To calculate the lift curve slope we just have to use equation 1.3 with wing CLCL and
10 deg because the wing airfoil is symmetrical; the efficiency is calculated dividing the
wing CL by the airfoil Cl (which is approximately 2π). The trends of the CL results can be
graphically represent in the figure below:
(j) Based on your results, where do you expect stall to occur first?
The stall occur first at the middle of the wing. At the tips the induced velocity due the vortices
is large therefore the effective angle of attack is lower than the actual wing of attack; on the
other side in the center of the wing the induced angle is lower so the effective angle of attackis closer to the wing angle of attack so this region will stall first.
2. (15%) Analyze the following case:
AR = 10
λ = 0.2, 0.6, 1.0 (sweep)
Λ = 0 deg
α = 10 deg
(a) What is the MAC and speed for each case to match the required Reynolds number?
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 6/13
(b)
Co-plot the spanwise lift coefficient distributions.
(c) Co-plot the downwash distributions.
(d) Co-plot the wing planforms.
0
0.2
0.4
0.6
0.8
1
1.2
-20 -15 -10 -5 0 5 10 15 20
C L
Wing Span [ft]
CL distributions
lambda = .2lambda = .6lambda = 1
-50
-45-40
-35
-30
-25
-20
-15
-10
-5
0
-20 -15 -10 -5 0 5 10 15 20
D
o w n w a s h [ f t / s ]
Wing Span [ft]
Downwash distributionslambda = .2
lambda = .6
lambda = 1
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 7/13
(e) Tabulate the wing lift coefficients CL.
(f) Discuss the eff ect of taper ratio on the CL distribution.
If we decrease the taper ratio (tip chord becomes lower than root chord) then the lowest
downwash is located at the wing tip, this implies in a lower induced angle of attack (the
effective angle of attack is closer to the wing angle of attack) therefore the is
effectively bigger in this region, which implies in a greater CL.
(g) Discuss the eff ect of taper ratio on the downwash distribution.
Due the circulation distribution in this wing the downwash is bigger in the middle of
the wing and lower in the wing tips.
(h) Discuss the eff ect of taper ratio on CL.
The wing with the taper ratio around .5 presents the maximum CL and is the wing that
presents a similar performance to the elliptical wing (the lowest induced drag planform)
(i)
Calculate the lift curve slope of each wing and determine the wing efficiency e.Show your work and discuss (as compared to each other and the elliptical case).
-14
-12
-10
-8
-6
-4
-2
0
2
4
6
-6 -4 -2 0 2 4 6Wing Span [ft]
Wing planform
lambda = .2
lambda = .6
lambda = 1
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 8/13
(j) Based on your results, where do you expect stall to occur first?
If the wing is tapered, with the same airfoil and no twist angle, the stall occurs first at
the tip and then progress to the wing center.
3. (15%) Analyze the following case:
AR = 10
λ = 1
Λ = −30, 0, 30 deg (sweep)
α = 10 deg
(a) What is the MAC and speed for each case to match the required Reynolds number?
(b)
Co-plot the spanwise lift coefficient distributions.
(c)
Co-plot the downwash distributions.
0
0.2
0.4
0.6
0.8
1
1.2
-20.00 -15.00 -10.00 -5.00 0.00 5.00 10.00 15.00 20.00
C L
Wing Span [ft]
CL distributions
gama [deg] = 30
gama [deg] = 0
gama [deg] = -30
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 9/13
(d)
Co-plot the wing planforms.
(e) Tabulate the wing lift coefficients CL.
(f) Discuss the eff ect of sweep on the Cl distribution.
-45.00
-40.00
-35.00
-30.00
-25.00
-20.00
-15.00
-10.00
-5.00
0.00
-20.00 -15.00 -10.00 -5.00 0.00 5.00 10.00 15.00 20.00
D o w n w a s h [ f t / s ]
Wing Span [ft]
Downwash distributions
gama [deg] = 30
gama [deg] = 0
gama [deg] = -30
-8
-6
-4
-2
0
2
4
-6 -4 -2 0 2 4 6
Wing Span [ft]
Wing planformgama [deg] = 30
gama [deg] = 0
gama [deg] = -30
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 10/13
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 11/13
(c) Co-plot the downwash distributions.
(d) Co-plot the wing planforms.
0
0.2
0.4
0.6
0.8
1
1.2
-30.00 -20.00 -10.00 0.00 10.00 20.00 30.00
C L
Wing Span [ft]
CL distributions
lambda = 1
lambda = 1.5
lambda = 2
-45.00
-40.00
-35.00
-30.00
-25.00
-20.00
-15.00
-10.00
-5.00
0.00
5.00
-30.00 -20.00 -10.00 0.00 10.00 20.00 30.00
D o w n w a s h [ f t / s ]
Wing Span [ft]
Downwash distributions
lambda = 1
lambda = 1.5
lambda = 2
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 12/13
(e) Tabulate the wing lift coefficients CL.
(f) Discuss the eff ect of taper ratio on the Cl distribution.
Since we are using LLT method the sweep is not taken in account, so the results will
be the same if we simulate an unsweep wing. Moreover, if we increase the taper ratio
the wing section CL becomes greater in the central region of the wing than the tip.
(g) Discuss the eff ect of taper ratio on the downwash distribution.
When we increase the taper ratio the downwash tends to decrease until 0, when it
becomes an “upwash”, this means that the airfoil in the wing span center actually
experiences a bigger angle of attack than the wing. From the downwash distribution we
can conclude that the high tapered wing experiences less induced drag, but on the other
hand it cannot have good structural characteristics.
(h) Discuss the eff ect of taper ratio on CL.
Increase the tapper for values bigger than one decreases the wing CL, we can see that
from the CL distribution. The wing CL is proportional to the product of the section CL
by the its chord, and the region with large chord has lower lift coefficient and vice-
-8
-6
-4
-2
0
2
4
-10 -5 0 5 10
Wing Span [ft]
Wing planform
lambda = 1
lambda = 1.5
lambda = 2
8/9/2019 aerodinamica aplicada
http://slidepdf.com/reader/full/aerodinamica-aplicada 13/13
versa; then increasing the taper ratio just maintain this kind of behavior (high lift
coefficient at the tip and lower in the root).
(i) Calculate the lift curve slope of each wing and determine the wing efficiency e.
Show your work and discuss (as compared to each other and the elliptical case).
(j) Based on your results, where do you expect stall to occur first?
The stall occurs first at the central region of the wing, because this part has higher
effective angle of attack.
Recommended