View
3
Download
0
Category
Preview:
Citation preview
+12V Constant = GREEN / BLACK
+12v Acc. Switched = GRAY / YELLOW
-12V Chassis Ground = BLACK / PINK
+12V Illumination =
+12V Dimmer =
Amp Remote =
LF+ = ORANGE / GREEN
LF- = BLUE / WHITE
RF+ =WHITE / GREEN
RF- = GREEN / ORANGE
LR+ = GRAY / BLUE
LR- = TAN / YELLOW
RR+= ORANGE / RED
Dash Type: Double DinAftermarket Type: Single/Double DinKit: FD1424B/FD1426BHarness: FDSRAntenna Adapte: CRAB
About the Vehicle
Make: FordModel: MustangYear: 2005-09
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Rear
Ford Mustang
RR- =BROWN / PINK
NOTES
Upper Door : 6X8'' MidrangeSpeaker Adapter: SA68Speaker Harness: SHFD03BFactory Assembly: (4) T-20 Torx screws.
Speaker Sizes
Shaker 500 comes equiped with a 8'' midbass in lower part of the door.Speaker adapter is suitable for component set in shaker systems.
Shaker 1000 comes equiped with a 8'' midbass on lower part of door and (2) 10'' subs in trunk.
Dimensions:W= 5.1/4''D= 18''L= 7.1/4''
NOTES
Rear Deck : 6x8"' speakersSpeaker Adapter: SA68Speaker Harness: SHFD03BFactory Assembly: T-20 Torx screws.
OPTIONS
MP3 PLAYERSHAKER 500SHAKER 1000SUBWOOFER6 DICS CHANGER
AMPLIFIER LOCATIONS:Shaker 500: Pasenger's kick panelShaker 1000: Passenger kick panel, rear sub amp is in passenger quarter panel in trunk.
Dimensions:W= 5.1/4''D= 2.1/2''L= 7.1/4''
2005-09
Ford MustangImages
Radio
Front
1. Remove (8) 7mm. botls surrounding the door panel.2. Using the Panel Removal Tool remove panel surrounding mirror controls, unplug and lift away.3. Using Panel Removal Tool remove cup behind doorrelease handle.4. Remove T30 torx head screw.5. Using Panel Removal Tool plastic housing surroundingpower window controls.6. Remove (1) 7mm bolt." If shaker 1000 remove trim ring surrounding bottomdoor speaker, remove (8) 7 mm bolts.7. Remove inner panel inside door grip8. Remove (1) T30 torx head screw.9. Slide door panel up disconnect harnesses and removedoor panel
1. Using a PRT pry upward gently on speakergrill attached to the rear deck.2. Remove (4) T20 torx head screw securing the speaker.3. Liftaway, disconnect, and remove.
Radio removal
Front speaker
Rear speaker
1. Remove (2) phillips head screws under rearportion of center counsole lid.2. Remove (2) 10mm nuts located under carpetin center counsole.3. Pull down shift knob boot.4. Unscrew shift knob and remove.5. Using Panel Removal Tool unsnap 2 clips located on front corners of center counsole and lift away.6. Using Panel Removal Tool unsap outer panels surrounding radio cavity.7. Remove (6) 7mm bolts, unsnap panel and disconnect plugs and lift away.8. Remove (4) 7mm bolts and remove radio..
Front Speaker
2005-06
Recommended