Web viewDECANTER CENTRIFUGE QUESTIONAIRRE. 1. What is the name of slurry to be processed? _____ 2....

DECANTER CENTRIFUGE QUESTIONAIRRE

1. What is the name of slurry to be processed? __________________________

2. What is the technical name of the liquid phase?__________________________

3. What is the density of the liquid phase?_______________________________________

4. What is the technical name of suspended insoluble solids in the slurry ?________________

5. What is the density of the suspended insoluble solid?_____________________________

6. What is the % w/v of suspended solids in the feed slurry?_______________________

7. Are the solids crystalline or amorphous in nature?_____________________________

8. What is the viscosity of the feed slurry?____________________________________

9. Is the liquid inflammable? If yes, give its properties like flash point etc, LEL (Lower Explosive Limit) value, etc. Flash Point:________deg.C LEL Vallue: ___________

10. Which is the product after separation? solid / liquid_________________________

11. What is the feed slurry temperature (0C) and temperature of operation ?_____________deg.C

12. How is the separation being done now ?_______________________________

13. What is the separational capacity required in kg/hr or m3/hr of feed slurry?______________

14. Does the Decanter Centrifuge need any special MOC of process contact parts other than Stainless steel (SS316)? If yes, state your preferred M.O.C __________________________

15. What is the % solid recovery / removal targeted ______________%

16. Any other relevant data that you would like to provide, please mention below such as:

Requirement of Inert gas (N2) Blanketting: ________(Yes} ________(No)

Any other requirements: …………………………………………………………

17. Certification Required (if any)

a) CE……….. b) U/L……………..c) ATEX………..

18. Installation Site Area Classification :…………..

19. Required Standards for compliance:………………..