Circuits in Play Dough | That Conference 2015

  • Published on
    19-Aug-2015

  • View
    87

  • Download
    0

Transcript

1. @scichelli #thatCircuits Facilitated by Sharon Cichelli Principal Technical Lead Headspring in Austin, Texas With thanks to Squishy Circuits University of St. Thomas http://www.stthomas.edu/squishycircuits/ Circuits In Play Dough 2. Try this! If the blobs touch, the LED wont work. 3. Building a Circuit A circuit is an unbroken loop for electricity to flow through. Use the dough to connect each LED leg to a battery terminal. But dont let the two clumps of dough touch each other. Thats a short circuit. Not lighting? Flip the orientation of the LED. Nothing special about the dough; salt water conducts electricity. (See recipe next.) 4. Mix: cup water tablespoon vegetable oil food coloring Stir that into: 1 cup flour cup salt Mix it, then knead it with extra flour until it is the consistency of fun. Conductive Play Dough 5. Motors! And buzzers! 6. Motors and Buzzers 9 volts is too much for these motors. They shut down to protect themselves. Each AAA battery is 1.5 volts, so two together gives 3 voltsjust right. Use foil instead of dough. The dough has a high resistance, so it starves the motor of enough current. The foil is more conductive. The buzzer motor is like the one in your phone. 7. Watch out for short circuits Battery terminals connected directly to each other get hot! An LED connected directly to the battery ruins the LED. 8. Short Circuits A short circuit happens when current flows through a different path than the one you wanted. In the LED + dough circuit, if the dough blobs touch, current will go there instead of through your LED. So the LED doesnt light. Foil has much less resistance than dough; foil lets more current through. LED + foil, the LED gets more current than it can handle. Permanently. Did you fritz an LED during the workshop? Dont sweat it; they cost pennies. Now were learning about current! 9. Keep making circuits! The recipe is a few slides earlier. Batteries, battery holders, LEDs, motors, speakers, sensors can be found on Amazon, eBay, Adafruit.com, Sparkfun.com, and at Frys and Radio Shack. (Shush. I miss the Shack.) These LEDs are through-hole (not itty bitty surface mount), 10mm diameter (5mm is fine), and have a forward voltage (minimum volts to work) of about 2.7 volts. 10. Thanks to our sponsors!

Recommended

View more >