1. Plastics and other materials for industrial useLaura Andreu
Garcia
2. IndexPlasticsObtening processMolding of plasticsTechniques of
mechanizationTreatment of resideu plasticsStone
materialsConglomerateCeramic materialsTools for stone materials 3.
Index PlasticsPlasticsAdvantagesObtention They are
obteningDescriptionTypesof petrol and naturalgasPlastics are
materialsthat are easy to modelate.Thermoplastics Thermostable 4.
Obtening process Index 5. IndexMolding of plasticsTechniques for
molding plastics:InjectionCompressionCalendering TechiquesSoplado
Empty Extrussion 6. IndexTechniques for mechanizationFor work with
plastics we have to aply this technoques: T c n ic a s C o rte y U
n io n e s d eM a rc a d o a s e rra d oT a la d r a d oro tu ra p
l s t ic o sU n i n p o rU n i n p o r U n i n a d h e s i nc o h e
s i nm e c n ic a 7. IndexTreatment of residue
plasticsRESIDUE(plastics) Solucions for its storageDumpsContainers
of selectivecollection 8. IndexStone materialsThe stone materials
are those that derived from the stone.From them, we can get the
sand,gravel, slabs, tiles and briks.These materials are very useful
for the constructions. Some of these materials are the BINDERS 9.
IndexConglomerateA conglomerate is a mass composed of various
elements, so they arecohesive. Depending if the aggregate issand or
gravel we can get: ConcreteMortar 10. IndexCeramic materialsCeramic
materials are those formed by a mixture based on the clay andwhich
are baked at high temperatures.Examples of ceramic materials
StonewareTiles Refractories 11. Index Tools for stone
materialsPalaPeakPalettePickaxeFlatChiselPot Tile cutters 12. THE
END 13. AdvantadgesPassiveresistanceLight Easy to work and
moldingGood estetic Slow cost ofpresentation produccion 14.
InjectionMolten plastic is injected into the mold and then removed.
15. CompressionPressing the plastic into a mold to take the form
16. EmptyIntroducing a plastic sheet on a mold that heats and then
a vacuumwhich causes the laminate to adhere to the mold and
acquires itsshape. 17. ExtrussionA screw press and forced out the
mass through the nozzle. 18. SopladoMaterial is introduced into a
cylinder in a mold, this is closed andair is introduced until the
desired shape. 19. CalenderingIntroducing a plastic mass into a
rollers,the mass leavewith flat-shaped. 20. DumpsThey are places
where the trash is finaly dipositte. 21. Containers of selective
collectionTo have information about recycle click
here:http://www.recycling-guide.org.uk/ 22. BindersAre materials
that when are mixed with water harden.They are widely used in the
works.The most used Cement Lime Plaster
