SPECIAL INJECTION MOLDINGSPECIAL INJECTION MOLDING

COINJECTION MOLDING

GAS ASSISTED INJECTION MOLDING

REACTION INJECTION MOLDING

COINJECTION MOLDINGCOINJECTION MOLDING

•TWO OR MORE PLASTICS ARE “LAMINATED” TOGETHER

•THEY MUST BE COMPATIBLE TO PROVIDE PROPER ADHESION

•MELTING AT APPROX. SAME TEMPERATURE

•SPECIAL MOLD DESIGN IS NORMALLY REQUIRED

NEW TECHNOLOGY OF INJECTION

ROTATIONAL MOLDING

UPLIGHTER USED FOR ROAD CONSTRUCTION

FUEL TANK

GAS ASSISTED INJECTION MOLDINGGAS ASSISTED INJECTION MOLDING

•INTERNAL •EXTERNAL

WATER INJECTION MOLDING(WIM)WATER INJECTION MOLDING(WIM)

WATER INJECTION MOULDING(WIM)NEWMETHODS OF USING WATER INSTEAD OF GAS TO FURTHER REDUCE TIME CYCLES OF THICK SECTION TUBULAR PRODUCTS.

STRETCH BLOW MOLDINGSTRETCH BLOW MOLDING

NOTE: IT IS SOMETIME CALLED INJECTION BLOW MOLDING

STRETCH BLOW MOLDINGSTRETCH BLOW MOLDING

NOTE: IT IS SOMETIME CALLED INJECTION BLOW MOLDING

METAL INSERTMOLDING PROCESSMETAL INSERTMOLDING PROCESS