Mori SeikiNT/NTX 1000, 2000Toolholder Program

OD clamping unitStandardC4-TRE-MS40A

(343-830111C293-RC)C4

StandardC4-TLE-MS40A(343-830111C293-LC)

C4

OD clamping unit, both sidesStandardC4-TRE-MS40A-DT

(343-830111C294-RC)C4

StandardC4-TLE-MS40A-DT(343-830111C294-LC)

C4

Face and ID clamping unitStandardC4-TRI-MS40A

(343-830111C295-RC)C4

StandardC4-TLI-MS40A(343-830111C295-LC)

C4

Face and ID clamping unit, back setStandardC4-TRI-MS40A-SS

(343-830111C505-RC)C4

StandardC4-TLI-MS40A-SS(343-830111C505-LC)

C4

Cut-off holder, adjustableStandardAPB-TNE-MS40A-25SH 32

Cut-off holder, adjustableFor quotationIC 80

bar343-810100R4(APBR-MS40A-25-HP)

HF=25

For quotationIC 80bar

343-810100L4(APBL-MS40A-25-HP)

HF=25

OD drill/milling unitFor quotationEC1:1343-830820N1589

(410103008-40)C3

StandardIC 80bar

1:1C3-DNE-MS40A-I(410103016-40)

C3

StandardEC1:1C4-DNE-MS40A-E(410104153-40)

C4

08.04.14Subject to change without notice

NT/NTX 1000, 2000Coromant Capto® - Standard Program

Face drill/milling unitFor quotationEC1:1343-830820N2468

(410503032-40)C3

For quotationIC 80bar

1:1343-830820N2469(410503033-40)

C3

StandardEC1:1C4-DNI-MS40A-E(410504298-40)

C4

StandardIC 80bar

1:1C4-DNI-MS40A-I(410504299-40)

C4

Face back set drill/milling unitFor quotationEC1:1343-830820N2305

(410503029-40)C3

For quotationIC 80bar

1:1343-830820N1884(410503023-40)

C3

08.04.14Subject to change without notice

NT/NTX 1000, 2000Coromant Capto® - Standard Program