Questions about ATOMIC products? Give us a ring! 717-626-4408www.atomicdesign.tv
STEP ONE Attach the Hanging Clamp to truss. Insert the Polestar Pole Male end into the Female connection point on the Hanging Clamp. Twist until you hear the click, indicating a secure connection.
STEP TWO Insert the Male end on a Poppy or another Polestar Pole into the end of Polestar pole attached to the base. Twist until you hear the click, indicating a secure connection.
Repeat until you have your desired configuration.
STEP THREEInsert the Male end of the final Poppy into the Female connection point. Twist until you hear the click, indicating a secure connection.
NOTEThe final Poppy will have no Female connection point on bottom.
MODULAR SYSTEMS
HANGING POPPIES
INSTALLATION INSTRUCTIONS
Page 1 of 1
Questions about ATOMIC products? Give us a ring! 717-626-4408www.atomicdesign.tv
STEP ONEInsert the Polestar Pole Male end into the connection point on the polestar base. Twist until you hear the click, indicating a secure connection.
STEP TWOInsert the Male end on a Poppy or another Polestar Pole into the end of Polestar pole attached to the base. Twist until you hear the click, indicating a secure connection.
STEP THREEInsert the Male end of the final Poppy into the Female connection point. The final Poppy will have no Female connection point on top. Twist until you hear the click, indicating a secure connection.
MODULAR SYSTEMS
STANDING POPPIES
INSTALLATION INSTRUCTIONS
Page 1 of 1