Transcript
Page 1: GROUP 10: FRONT AXLE - VETERAN · PDF fileFront Axle Assembly Typical Exploded Parts View Most parts in stock for most models Shim, Steering Knuckle Flange Bearing Cap — Upper

44 Phone: 1-641-472-4665 | [email protected] | Toll Free: 1-888-695-0578 (ORDERS ONLY)

GROUP 10: FRONT AXLE

The Lock Right Locker allows you to keep your hands on the wheel and your mind on the terrain...

Lock Right Differential Locker These kits replace the differential spider gears with a ratcheting assembly that transfers torque in a reversed fashion from normal differentials. Lock Right works automatically, so you can keep your hands on the wheel and your mind on the terrain. Because your ring and pinions are not disturbed during instal-lation, no gear lash adjustments are required. If you want to get a good grip with both front or rear wheels the Lock Right should do the job for you. Fits Vehicle Type: D,E,F $385

New Superwinch Lockout Hubs

Fits WC 3/4 Ton, 1 Ton •PW, WC 1 1/2 Ton (6X6), M-37 $159 Dana44 W100 & W200 •$165

Selectro Lockout Hubs W-300-’58-68 • $275 W-300-’69-74 • $275 M715 Kaiser Jeep • $275

Selectro Lockout Hubs WC 1/2 Ton $275

New SelectroLockout Hubs (not pictured) Internal--non flanged. Fits W100 1969-71 $325

FRONT AXLE SEAL & GASKET SETS M-37, Civ PW, WC 6x6 and WC 3/4 Ton Late (9 5/8” diff.) Front Axle Seal and •Gasket Set. Includes: inner axle oil seal (2), hub seals (2), pinion seal (4“ diam-eter), Knuckle felt set and gasket set includes all gaskets (except knuckle cap & fl ange) $75 Set 1/2 Ton WC & VC Front Axle Seal and Gasket Set. Includes: inner axle oil •seal (2), front hub seal (2) - specify VC 1/2 ton or WC 1/2 ton, differential pinion seal 8 3/4” small ring gear (1), front knuckle felt set, front axle gasket set includes all gaskets (except knuckle cap & fl ange) $65 Set 3/4 Ton WC Early (8 3/4” diff.) Front Axle Seal and Gasket Set. Includes: inner •axle oil seal (2), hub seals (2), pinion seal ( 3.5“ diameter), knuckle felt set and gasket set includes all gaskets (except knuckle cap & fl ange) $65 Set

Front/Rear Axle Differential Assembly Typical Exploded Parts View Most parts in stock for all models

Differential Gears Repair Kit for all 3/4 & 1 ton Dodge Dif-ferentials, includes gaskets, spider gears, side gears, pins, etc. CC1057780 $65

Stud, Drive Flange NEW [Ord # 7351088] Fits Vehicle Type: A,B,C,D,E,F Part # 10:916414 $2

Nut, Drive Flange Stud NEW Fits Vehicle Type: A,B,C,D,E,F Part # 10:125913 $1

Stud, Drive Pinion Carrier, Conversion NEW This stud is made spe-cifically for converting small early type axle housing to accept large 9 5/8” differential. Important: Diff. inspection cover must be replaced with late style. Fits Vehicle Type: B,D Part # 10:CCS9999 $5

Lockout Hubs Save wear and tear on your front axle. Lim-ited lifetime warranty.

Page 2: GROUP 10: FRONT AXLE - VETERAN · PDF fileFront Axle Assembly Typical Exploded Parts View Most parts in stock for most models Shim, Steering Knuckle Flange Bearing Cap — Upper

45 Phone: 1-641-472-4665 | [email protected] | Toll Free: 1-888-695-0578 (ORDERS ONLY)

GROUP 10: FRONT AXLE

Shim, Drive, Flange NOS.005

Fits Vehicle Type: A •Part # 10:915580 $4 .007 Fits Vehicle Type: A •Part # 10:915581 $4 NOS .020 •Fits Vehicle Type: A Part # 10:915582 $4

Retainer, Flange, Oil Seal NOS [Ord # 7348992] Fits Vehicle Type: B,C,D,E,F Part # 10:925581 $12.50

Seal, Drive Pinion —Small (approx. 3 1/2”diameter) NOS (8 3/4 “small differential). Fits Vehicle Type: A,BPart # 10:856864 $15

Gasket, Drive Flange NOS 1958-68 only. Fits Vehicle Type: H Part # 10:1795195 $2

Retainer, Oil Seal Felt, Flange Joint USED [Ord # 7348991] Fits Vehicle Type: B,C,D,E,F Part # 10:924638 $2

Front Axle Assembly Typical Exploded Parts View

Most parts in stock for most models

Shim, Steering Knuckle Flange Bearing Cap — Upper

NEW [Ord # 7348994].005 Fits Vehicle •Type: B,C,D,E,F Part # 10:924591 $3.50 NOS .005 Half-Ton. Fits Vehicle Type: A •Part # 10:916855 $3.50 NEW [Ord # 7349269] .007 Fits Vehicle •Type: B,C,D,E,F Part # 10:924592 $3.50 NOS .007 Half-Ton. Fits Vehicle Type: A •Part # 10:916856 $3.50 NEW [Ord # 7349268] .020 •Fits Vehicle Type: B,C,D,E,F Part # 10:924593 $3.50 NOS .020 Half-Ton •Fits Vehicle Type: A Part # 10:916857 $3.50

Seal, Inner Axle NOS Fits Vehicle Type: A •Part # 10:599086 $7.50 NOS [Ord #500057] •Fits Vehicle Type: B,C,D,E,F Part # 10:924432 $7.50

Guide & Seal, Inner Front Axle Shaft NEW Fits Vehicle Type: G Part # 10:1791964 $15

Seal, Guide Inner Front Axle Shaft NEW Fits Vehicle Type: H Part # 10:1795508 $22

Guide, Inner Front Axle Shaft NEW Fits Vehicle Type: H Part #10:1795509 $35

Front Axle Shafts VC 1/2 ton right assembly Bendix •CC598850 $150 WC 1/2 ton right assembly Bendix •CC915114 $150 WC 1/2 ton left assembly Bendix •CC915115 $150 WC 3/4 & 6x6 right assembly Bendix •CC924244 $125 WC 3/4 & 6x6 left assembly Bendix •C0924245 $125 M-37 & PW right inner Tracta •CC1268430, CC1189230 $75 M-37 left inner Tracta CC1268431 • $75 PW left inner Tracta CC1189231 $75 M37 & PW outer Tracta CC1189232 • $75 M37, PW, W300 Tracta joint(2 piece) •-not shown—USED $50, NOS $100

5.83 Ring & Pinion Gear Sets Small 8 1/4” type for early 3/4 •ton WC models CC922848 $200 Large 9 5/8”, 4.88 ring •and pinion set $455 (call for availability)

Seal, Drive Pinion— Large (approx. 4” diameter) NEW [Ord # 7411822](9 5/8” large differential only). Fits Vehicle Type: B,C,D,E,FPart # 10:928114 $23.50

Gasket, Drive Flange NEW [Ord # 7351041] Fits Vehicle Type: B,C,D,E,F Part # 10:915565 $2

Inner Front Axle Shafts (not shown) NOS 1958-68 Dana 70 23 •Spline. Fits Vehicle Type: H Right Part # 10:1795502 $200 Left Part # 10:1795503 • $200

Page 3: GROUP 10: FRONT AXLE - VETERAN · PDF fileFront Axle Assembly Typical Exploded Parts View Most parts in stock for most models Shim, Steering Knuckle Flange Bearing Cap — Upper

46 Phone: 1-641-472-4665 | [email protected] | Toll Free: 1-888-695-0578 (ORDERS ONLY)

GROUP 10: FRONT AXLE

An Important Note Concerning Spicer/Dana 44 & Spicer/

Dana 70 Front Axle Parts: Prices may be subject to change.

Please call us for our most current price on these items.

Cone Bearing, Bronze, Steering Knuckle Flange - Upper

NOS [Ord # 7705714] Fits Vehicle Type: D,E,F,G •3,500 lb. axle only),H Part # 10:1270396 $55 NOS [Ord # 7705714] Fits Vehicle Type: B,C •Part # 10:924436 $55

Socket, Wheel Bearing Adjusting Nut 2 9/16” 6-Sided

NOS Fits Vehicle Type: H •Part # 10:WBNW002 $25

Axle Housing Cover Gaskets Large—NOS B-(large differential •only). Fits Vehicle Type: B,C Part # 10:929879 $7.50 Small—NOS B-(small differential •only). Fits Vehicle Type: A,B Part # 10:915098 $7.50 Drive Pinion Carrier Gaskets •—Large Differential NOS [Ord # 7411818B]-(large dif-ferential only). Fits Vehicle Type: B,C,D,E,F Part # 10:929877 $7.50 Small Differential—NOS B-(small •differential only). Fits Vehicle Type: A,B Part # 10:952554 $7.50

Oil Seal, Neoprene, Front Knuckle-Large NOS 3,500 & 4,500 lb axle-only Fits Vehicle Type: G,H Part # 10:1795511 $39 CALL FOR AVAILABILITY

Bushing, SteeringKnuckle & Axle Housing REP [Ord # 7351046] (4) required on front axle. Fits Vehicle Type: B,D,C,E,FPart # 10:924249 $28

Felt, Oil Seal, Front Steering Knuckle NOS 3,000 lb axle only. Fits Vehicle Type: G Part # 10:1791960 $8

Cup, Bearing, SteeringKnuckle Lower/Upper

NEW Fits Vehicle Type: A •Part # 10:598837 $9.50 NEW Fits Vehicle Type: B,C,D,E,F,G •Part # 10:927013 $12.50

Felt, Oil Seal, Front Steering Knuckle NOS 3,500 & 4,500 lb axle-only. Fits Vehicle Type: G,H Part # 10:1795514 $8

Gasket, Steering Knuckle, Bearing Cap—Lower NEW [Ord # 7348988] Fits Vehicle Type: B,C,D,E,F Part # 10:924594 $1.50

Oil Seal, Neoprene, Front Knuckle—Small NOS 3,000 lb axle only; (2) required. Fits Vehicle Type: G Part # 10:1791957 $15 Cone Bearing, Steering

Knuckle Flange - Lower NEW Fits Vehicle Type: A •Part #10:598838 $15.50 NEW [Ord # 705436] Fits Vehicle Type: •B,C,D,E,F,G (G-except 3000 lb axle),H Part # 10:927014 $22.50

Gasket, SteeringKnuckle Flange

NEW[Ord # 7348989] •Fits Vehicle Type: B,C,D,E,F Part # 10:924634 $5 NEW Fits Vehicle Type: A •Part # 10:915088 $5

Cup, Bearing, Steering Knuckle NEW 3,000 lb. axle only. Fits Vehicle Type: G Part # 10:1793515 $6.50

Cone Bearing, Bronze, Steering Knuckle Flange—Upper, Half-Ton NOS Fits Vehicle Type: A Part # 10:916060 $22.50

Bushing, Upper Steering Knuckle Pivot-Splined NOS 3,000 lb. axle only (1959-68). Fits Vehicle Type: G Part # 10:2511521 $45

Bushing, Steering Knuckle — Half Ton REP (2) required. Fits Vehicle Type: A Part # 10:915579 $28

Bushing, Upper Steering Knuckle Pivot-Keyed NOS 3,000 lb. axle only (1969-71). Fits Vehicle Type: G Part # 10:1924416 $45

Bushing, Steering Knuckle NEW Fits Vehicle Type: H Part # 10:1795578 $35

Retainer,Oil Seal, Front Steering Knuckle NOS 3,500 & 4,500 lb. axle only (4) required. Fits Vehicle Type: G,H Part # 10:1795512 $5

Cone, Bearing, Lower Steer-ing Knuckle NEW 3,000 lb. axle only. Fits Vehicle Type: G Part # 10:1793514 $16

Retainer, Oil Seal Front Steering Knuckle NOS 3,000 lb axle only (4) required. Fits Vehicle Type: G Part # 10:1791958 $5

Bushing, Steering Knuckle NEW Fits Vehicle Type: G Part # 10:1791706 $28

Socket, Wheel Bearing Adjusting Nut 2 9/16” 8-Sided NEW Fits 3/4” drive. Fits Vehicle Type: A,B,C,D,E,F Part # 10:WBNW001 $49


Recommended