Transcript

Application Tip:Fabricating AcrylicBy: Regional Supply

There are many factors that affect the lookand versatility of your acrylic products.

• Care and Cleaning• Cutting & Scrubbing• Drilling• Finishing

The most important step in acrylicfabrication is cleaning.

• Always use a mild soap or a commercially available plasticcleaner like Novus or Brillianize.• Use a lint free cloth and be very careful not to scrub tooaggressively.• Avoid cleaners that contain ammonia or alcohol.

Acrylic can be cut in a variety of ways

Acrylic sheets up to 1/4 inch thick can be scribe cut. Scorerepeatedly along a straight edge with a plastic cutting tool. Score1/3 of the way through the sheet. Align the score with the edgeof a table and apply gentle pressure to break the sheet along thescore.Acrylic can be cut with a variety of saw equipment. Bladeselection is critical with regards to edge !nish. Table and panelsaws are the best option for high volume straight cuts. A 10-inchcarbide tipped blade with triple chip 80 teeth pin isrecommended.

To know the correct cutting speed,use the following table:

6 inch blade - - - - - 6400 RPM8 inch blade - - - - - 5000 RPM10 inch blade - - - - 4000 RPM12 inch blade - - - - 3000 RPM14 inch blade - - - - 2800 RPM16 inch blade - - - - 2400 RPM

Blade selection is critical. A !ne tooth blade is a must.Acrylic can also be routed, laser cut and machined.

ACRYLIC DRILLING IS BESTPERFORMED ON A DRILL PRESSUSING A 60 DEGREE BIT.

To know the correct speed based onbit diameter, use the following chart:

1/8 Drill Bit - - - - - 3500 RPM3/16 Drill Bit - - - - 2500 RPM1/4 Drill Bit - - - - - 1800 RPM3/8 Drill Bit - - - - - 1200 RPM1/2 Drill Bit - - - - - 900 RPM5/8 Drill Bit - - - - - 700 RPM

To finish the acrylic fabrication process, there area number of things that can be done.

• To improve the edges, scrape, sand, buff or #ame polish.• Acrylic can also be cemented or glued together quiteeasily. There are a number of different acrylic gluesavailable for this. Some are thin like water, others arethicker. Some adhesive is a two-part product like an epoxy.• Acrylic can easily be painted, screen printed, and respondswell to vinyl application. It can also be thermoformed, linebent and cold formed.

Read more and comment by visitingwww.TheLeadershipCircle.com

And clicking on “Leadership Quarterly”

- OR -

Get there directly atwww.RegionalSupplyBlog.com/2013/04/10/application-tip-

fabricating-acrylic/


Recommended