We are here to help! Please don’t hesitate to call us. Monday – Friday, 8:00am – 5:00pm EST

704-483-1900 www.getvelox.com1

INSTALLATION INSTRUCTIONS

Post Installation

Anchor one post first, then use chalk lines to build out from there. DO NOT anchor more posts until the entire system is installed (or if the system becomes unstable).

Adjustable Corner Post

Adjustable corner posts are used for inside corners...

…or odd angles.

4

HARDWARE: KITXGPOST

HARDWARE: KITXGADJ

Single Swing Door

CARRIAGE BOLT5/16” X 3” LONG

6

HARDWARE: KITXGSHD

SNAP LATCH

IF YOU ARE NOT USING THESNAP LATCH, YOU MUSTINSTALL THE INCLUDED

STRIKE BAR TO LATCH POST.

If installing our FortressInterlock please see detailed

in on instruc on in hardware box with the

interlock.

CANE BOLT ON DEAD SIDE OF

DOOR

CARRIAGE BOLT5/16” X 3” LONG

Double Swing Door

7HARDWARE: KITXGDHD

Inside View

*For an 8’ system, there will be aheader bar on top of the door.

If installing our FortressInterlock please see detailed

in on instruc on in hardware box with the

interlock.

Single Slide Door

Install d p nd doo in f of d p using wood blocks ovid to hold doo in po on a aching to posts

Mount p o tomo doo

8

HARDWARE: KITXGSTD

If installing ou FoInt lock p s s d d

in on ins on in h d bo with th

int lo

DETAIL I

DETAIL J

CARRIAGE BOLT5/16” X 3-1/2”

LONG

Double Slide Door

9

HARDWARE: KITXGDTD

A h o he pl hwelded o door e.

If in ing our Fo rIn erlo k p e ee de d

in on in on in h d box he

in erlo

Cut to Fit Panels - Width

9

WIDTH MODIFICATION – USE XGBC Modify in the field to create the exact panel width you need. XGBC includes 3 left hand and 3

right hand clips. A 6’ high system requires a total of 3 bolt-on clips while an 8’ high system requires a total of 5 bolt-on clips.

*When working on an 8’ high system, cut one side of the 66” high panel and the opposite side on the 24”.

Original size panel Cut panel to desired width with grinder

Modified panel, no clips

Modified panel with clips attached

Cut to Fit Panels - Height

HEIGHT MODIFICATION – USE XGBC-NF IF NEEDED Modify in the field to create the exact height you need.

If the bolt-on clips do not line up with pre-punched holes in the post, use XGBC-NF to secure panel to post

with the included self-tapping screws.

Original size panel Cut panel to desired height with grinder

Modified panel, no clips

Modified panel with clips attached

Bolt-on clip

Bolt-on clip with bolt

10

Double Slide Door

Line Post 2 ½” Square Post

Single Swing Door HLSO

Door Post 2 ½” Square with an Oversized Footplate

Solid Steel Panel

Panel

Single Slide Door

Lexan Panel

Husky Rack & Wire 704-483-1900

www.getvelox.com

Terms and conditions can be found on our web site Terms and conditions can be found on our web site 11

6146 Denver Industrial Park RoadDenver, NC 28037

Phone 800-438-5629Fax 704-483-1911

www.huskyrackandwire.com© 2015 Husky Rack & Wire previously Wireway Husky Corp.IMP # 22072 Item #80099