Upload
magdalen-ramsey
View
219
Download
0
Tags:
Embed Size (px)
Citation preview
Universal Holding Cabinet
Two screws hold each side; four
screws secure the top.
Driver boards
The panel holding the ON/OFF switch can be removed and placed out of the way, allowing
the component shelf to slide forward.
Component shelf slid forward. Note panel on top of unit.
Component shelf with top off
Motherboard
Control and heater plate connections
Disconnecting display from driver board
Control and heater plate wiring.
The bezels are removed by
loosening screws on the side of the
unit.
The bezel is slid from the cabinet.
Bezel and connecting ribbon cable
Slots, with front and rear bezels removed are disconnected from heat and control circuits and slid
from cabinet.
The heater plates are held in place in the slots by setscrews
under the foil cover. Find the setscrews by tracing the edge of the slot with a
finger.
Puncture the foil with an
allen wrench to remove the
setscrew.
Heater plate partially removed from slot.
Heater plate and wires atop slot.