Upload
ledat
View
254
Download
0
Embed Size (px)
Citation preview
SOP for AGT Unit Assembling
AGT Unit AGT Unit
Revision Tag for new AGT
Tool List
Wrench
Screw drive
Iron stick
Pliers
Disassemble the chain guard
Rear cover
Bottom cover
Clipping the shifting cable out of the gear box hole.
Loosen the screws to remove the cover
Disconnect three cables on PCB
1 2
3 4
Disconnect AGT electronic unit
1 2
3 4
Remove the rubber tube
Loosen the shifting cable with AGT Electronic Unit by 7mm wrench. Use the new AGT Electronic Unit to replace old one
1 2
4 3
Old
Revision Tag Use the 705 glue to fix the rubber tube
New
Fixing the AGT Electronic Unit on the mounting clamp set and tightening properly by screw driver.
Connecting all cables back to PCB
1 2
3 4
Tighten the screws on properly Add new tag on AGT cover
Clipping the shifting cable clip into the gear box by using a proper tool into the gear box hole.
Assemble the chain guard 1 2
3 4
Rear cover
Bottom cover
End