Sokratherm 40 400 Kw Eng 2011

Embed Size (px)

Citation preview

  • 7/28/2019 Sokratherm 40 400 Kw Eng 2011

    1/6

    Compact CHP units 40 400 kWcompact efficient reliable

    With their highly efficient, clean and economic productionofelectricity and heat, CHP units (Combined Heat andPower, also: cogeneration) make a substantial contribution

    to a sustainable energy supply.

    Compared to the conventional supply, natural gas poweredSOKRATHERM CHP units reduce the primary energyconsumption by ca. 40% and the CO2 emissions by ca. 60%.That is why such plants based on the highly efficient prin-ciple of cogeneration are supported by laws or subsidiesin many countries.

    SOKRATHERM, one of the leading German CHP unitmanufacturers in its power range, offers cogenerationunits fuelled by natural gas, sewage gas or biogas in fourpower classes.

  • 7/28/2019 Sokratherm 40 400 Kw Eng 2011

    2/6IndustrialsitesApplication examples

    of compact CHP units40 400 kW

    COGENERATION = EFFICIENT ENERGY

    CHP units allow the efficient generation of heat and poweron site and without transmission losses. In contrast to largepower plants, they can be turned on an off and regulatedto partial load within seconds. This possibility to quicklysupply electricity grants them an increasing importance inthe energy mix, also to balance the production fluctuationsof renewable energies.

    The core piece of the CHP unit is a combustion enginepowering an electricity generator. The generated power isconsumed by the on-site load or can be fed into the mains.The heat generated in the combustion process is extractedby a series of heat exchangers and can be used for heating,hot water generation, process heat or even cooling.

    With this double utilization of energy, our CHP units reach

    efficiency rates of ca. 90% and even higher if the optionalexhaust condensation heat exchanger is chosen.

    Conections for gas,heating water and exhaust

    Front-end operationby touchpanel

    FLEXIBLE APPLICATION

    Our CHP units may also be configured to take over the elec-tricity supply of defined consumers (e.g. pumps, sprin-klers, production lines, computers) in case of mains failure.

    It is also possible to fit them as hot coolers to operateon a higher temperature level (95/80 C) than standard(90/70 C) to supply e.g. absorption chillers.

    The modular design allows a combination of our compactCHP units in size and numbers to exactly match thebuilding and its users because hospitals have a differentpower demand than office buildings, swimming poolsother heating needs than industrial sites.

    SOKRATHERM cogeneration unitsIndividual plants for best energy utilisation

    Compact CHP unit type GG 50

    50 kW class

  • 7/28/2019 Sokratherm 40 400 Kw Eng 2011

    3/6

    With their compact design, our CHP units convert theengine power and combustion heat with the least possiblelosses into electricity and useable thermal heat. This way,the space requirement on site is minimized as well as theeffort for the insertion.

    RELIABLE OPERATION

    The ISO 9001 certified production tailored to the custom-ers needs is followed by an extensive test run and a sub-sequent first service before shipping. We manufacture ourcompact CHP units with switchgear cabinet integratedin the sound absorbing CHP case ready to operate and cancommission them very quickly. Their triple elastic bearingprevents vibrations from spreading to the building. There-fore, a separate founding is rarely required.

    Only long-term proven components from well-known pro-ducers are used our units. This way we achieve a minimumfault potential at maximum quality, which is regularly con-firmed by our customer satisfaction surveys.

    SERVICE

    An integral part of our offer are well-engineered mainte-nance concepts which are continuously adapted to the tech-nical progress. For every CHP project, we offer individualservice packages from the simple regular service withcustomer participation to the all-inclusive carefree packageincluding operation optimization and general overhaul.A network of service points makes sure that our customersalways have competent service personnel nearby.

    Hospitals

    Hotels

    Swimmingpools

    Nursinghomes

    Modular technology flexible and ecological

    Compact CHP unit type GG 140 Compact CHP unit type GG 237

    100 and 200 kW class

  • 7/28/2019 Sokratherm 40 400 Kw Eng 2011

    4/6

    Connections for heating waterand exhaust

    Maximum power onless than 5 m2 base area

    CHP UNIT SIZING

    To achieve the best economy, the CHP unit covers the heatand power baseload while the peak loads are covered by boil-er and power mains. The CHP size is usually determined bythe locations maximum heat demand (Qmax). Dependingon climate zone and the cost of power and gas, a profitableoperation can be reached when the heat output of the CHPunit is 10 30% ofQmax. In special cases, e.g. for peak oremergency power supply, the CHP unit is sized by the elec-trical power demand.

    MULTI UNIT PLANTS

    For better adaption to the heat demand and/or to achievea backup supply, the required power can be split up intoseveral CHP units.

    Officebuildings

    Residential

    buildings

    Qmax

    QCHP

    Day 365Day 1

    Process heat from CHP unit Hot water, dipping baths etc.

    Thermal heat from CHP unit

    Annual heat load curve

    (frequency distribution)

    Remaining

    heat from boiler

    Up to 1,600 kW in multi unit plants

    Qmax (kWth)

    300 11.800

    500 12,000

    1.900 13,500

    1,700 15,000

    up to 20,000

    CHP unit class (kWel)

    050 kW

    100 kW

    200 kW

    400 kW

    individual sizing

    Compact CHP unit type GG 402

    400 kW class

  • 7/28/2019 Sokratherm 40 400 Kw Eng 2011

    5/6

  • 7/28/2019 Sokratherm 40 400 Kw Eng 2011

    6/6

    SOKRATHERM CHP unit controlSafe and smooth operation

    Superordinate controls are also part of our product range:For the control of rather simple plants with a CHP unit,

    a boiler and a buffer, the MiniManager control is alreadyincluded. Plants with a CHP unit and e. g. several boilersor an extended buffer management can be controlled withthe MiniManager PRO system adapted to the specificCHP project.

    Large CHP plants with several CHP units, boilers and e.g.emergency power supply can be controlled with the Maxi-Manager. This secures a centrally supervised, efficient andruntime optimized operation of the single CHP units.

    SOKRATHERM GmbHEnergie- und Waermetechnik

    Head office/SalesMilchstrasse 12 D-32120 HiddenhausenTel. +49.5221.9621-0Fax +49.5221.66063e-mail: [email protected]

    Production/Service centerHelmestrasse 20 D-99734 NordhausenTel. +49.3631.9076-0

    Fax +49.3631.9076-20e-mail: [email protected]

    www.sokratherm.com

    CHP unit remote monitoring/Control

    (example)

    MiniManager Control of CHP unit, peak load boiler and buffer

    RemoteManager Remote monitoring and remote control+

    Every SOKRATHERM CHP unit comes with an industrialcomputer based iPC control. This does not only monitor

    the fully automatic operation but also provides a quick anddetailed insight into the plant via touchpanel.

    Our newly developed internet based RemoteManagerpermits the remote control and remote monitoring of thewhole plant from a desktop PC, via notebook or even bysmartphone. A multitude of interfaces secures the connec-tivity with external systems up to the integration intovirtual power plants to provide balancing energy.

    CHP unit Buffer

    5

    3 3

    3

    Boiler

    MiniManager

    MiniManager PRO

    Statusmessagesvia

    Smartphone

    Notebook

    PC

    SMS

    eMail

    Safe remote access via

    RemoteManager