Upload
mike-green
View
190
Download
0
Embed Size (px)
Citation preview
Simple mother daughter jewelry-diy wrapped bracelet
There’s nothing like conveying love to moms.
However, from right now, you can wear your
gratitude and thanks over your wrist with this diy
wrapped bracelet. It’s very easy and inexpensive to
make these mother daughter jewelry bracelets,
additionally, you can be as creative as you can.
Materials you’ll need in diy wrapped bracelet:
2mm Nylon Thread
Brass Chain
Alloy Pendants
Bead Tip
Lobster Claw Clasp
Jumpring
Glue
Side Cutting Plier
Instructions for mother daughter jewelry bracelet:
Step1: preparations
1. Cut a 100cm long nylon thread, and then fold in
half;
2. Next prepare a chain strand, about 60cm;
3. Take a scrap brass wire section and string the first
link on chain;
4. Wrap the brass wire around the folded location for
several turns. After that, remove the excess wire;
5. Apply a few glue onto the tip and then stuff into
the matching bead tip.
It’s a fun and easy to make this type of diy wrapped bracelet. By using a long strand of thick nylon thread
and a chain, your mom will appreciate receiving the kind of mother daughter jewelry bracelet from you.
Step4: add on the clasp
Hook on the clasp and decorative alloy pendant onto each bead tip by jumpring.
Such a diy wrapped bracelet is just a piece of cake
for you, right? Measure both your wrist and mom’s
to make sure you have made the right size for your
mother daughter jewelry gift. And besides this,
make another piece distinctively by differentiating
its color collocation may be enough.
Shop an array of beads and charms please click: http://www.pandahall.com/
Step2: braid the diy wrapped
bracelet
Start to work the bracelet refer to the way
plaiting 3-strand braid.
Step3: complement of entire
bracelet
When the length reach to three or four times
the length of your wrist circumference, end the
bracelet as you did in beginning.