Setting VC 4 and VC 12 For

Open X-Debugger and click at “Create”.

For slot 23 Click Traffic and control channel resources. Set as shown. Make sure control channel

number is the same as set in NMS

STM- Choose GMX interface used

TU12 : (1,1,1,1) VC4:1,TUG structure:1,1,1 Inst:VC12 no.

Control channel default should be set 9.

Select GMX2-A (for slot 23)

VC 4:1 VC12 Inst = 1 Unit slot = 23

The result should be like this.

Double click at GMX 2

GMX interface parameter for STM-1 and VC4 interface: TIM AIS action must be disabled. At NMS TIM

AIS action also must disable.

Select at GMX2 (23) Port X (According which port used)

Set STM-X (According which STM used such as 1, 4, and 16) Uncheck here.

Select GMX2 (25) Port X (According which port used). In this case port 2.

Double click at yellow interface.

Set STM-X (According which STM used) Uncheck here

Uncheck here VC: 4 = off

The usage must set not in use.

The TTI at send set default for GMX2 (23), GMX (25), VC4:1, VC12:1

Set default here

Set default here

Set default here

Set default here

Select VC12:1. Double click at yellow interface.

Uncheck here.

Click control channel. Set the usage in use and in the Octet Within Group set as shown.