When the job has to be done right the first time, call

Australian Leak Detection

Home Owners • Insurance Companies Structural Engineers • Plumbers

Property Managers • Pool Service Technicians Realtors • Building Contractors

Leak Detection Swimming Pools • Spas and Fountains

Water, and Gas Lines

Concealed Plumbing Leaks Under Slabs • Behind Walls • Main Service Lines

Residential • Municipal • Commercial

Our specially-trained experts use non-invasive leak detection equipment to accurately locate

hidden leaks behind walls and underground

before they require major home repairs.

Reducing your maintenance expenses

and unnecessary property damage.

www.Australian Leak Detection.com

LEAK DETECTION

WITHOUT DESTRUCTION

Call Australian Leak Detection and one of our expert leak specialists

will be happy to help.

5444. 8336

AustralianLeakDetection.com

Determine if you are at risk by checking the Signs and Symptoms on our website. For self tests, try the Meter Test for plumbing and the Bucket Test for pools and spas.

About Australian Leak Detection

Founded over 40 years ago, Australian Leak Detection sets the standard for non-invasive leak detection and repair with proprietary methods and technology. We now operate a network of highly trained Original Leak Specialists on five continents.

Each office independently owned and operated.

save water, save time, save resources...

Water leaks can damage your property, costing thousands of dollars to repair. Take control of the situation by calling Australian Leak Detection.

SAVE YOUR PROPERTYSAVE YOUR PROPERTY

Water leaks can damage your property, costing thousands of dollars to repair. Take control of the situation by calling Australian Leak Detection

www.Australian Leak Detection.com

Try these easy tests to determine if you have a leak.

Each office independently owned and operated.

Try The Meter Test

1. This test should be conducted for a 30 minute period, during which time no water is being used on the property.

2. Find your water meter, which is usually located in front of the house.

3. Write down the numbers indicated on the meter at the start of this test. The number on the far right is normally 1 litre.

4. Return to check the meter reading after 30 minutes have passed.

5. If the numbers have not changed, you do not have a leak in your pressurised water system. If the numbers have changed, continue with the following steps.

6. Shut off the values to all toilets in the house, along with any ice making machines, auto pool refill or anything else that uses water and repeat steps 1-4.

7. If the numbers have changed, this indicates water use. Your home or property may need a leak detection.

Bucket Test Your Pool

1. Bring the pool water to normal level. Turn off auto refill to pool (if applicable)

2. Fill a bucket with pool water to about 3 cm from the top.

3. Place bucket on the first or second step of pool.

4. Mark water level on inside of the bucket.

5. Shut off pump and mark pool level on the outside of the bucket.

6. Resume normal operation,

7. After 24 hours, compare the two water levels. If the pool water (outside mark) goes down more than the inside water level, there is probably a leak.

8. If it rains, both levels should go up by the same.

save water, save time, save money...

SAVE WATER NOWSAVE WATER NOWDo you have a high water bill? You may have a hidden plumbing leak. Try the seven steps below to determine if your property is leak free.

Look for these signs of a leaking pool, then follow the instructions to deter mine the rate of water loss

Call Australian Leak Detection and one of our expert leak specialists

will be happy to help.

5444. 8336LEAK DETECTION

WITHOUT DESTRUCTION