Problemløsning når “ Standardmodellering ” ikke slår til Indlæg ved ProUser møde 8-9 marts 2011

Dias nummer 1

Problemlsning nr Standardmodellering ikke slr tilIndlg ved ProUser mde 8-9 marts 2011Lektor Georg K. ChristensenKonstruktion & ProduktudviklingBygning 426 B#DTU Management Engineering, Technical University of DenmarkDispositionRundinger I ProE = et tre ugers kursus ?

Enkle, smarte og problematiske rundinger0) Nomenklatur1) Standard runding en pick and place feature variable radier med sketchcontrol / flade og kant/ Auto Round2) Runding af een kant3) Runding af to kanter med forskellig radius4) Runding af tre kanter med forskellig radius5) Referencer fra ProE Help-memnuen B) Nr standard lsningerne ikke slr til (eksempler)1) round & style p LEGO-arm2) warp #DTU Management Engineering, Technical University of Denmark0) Nomenklatur

Hovedbegreber i ProEs round

Referencer: kanter eller flader Rundings: pieces og transitioner

#DTU Management Engineering, Technical University of Denmark1) Standard runding en pick and place feature Insert/Auto Round

#DTU Management Engineering, Technical University of Denmark1) Round med flade + kant

#DTU Management Engineering, Technical University of Denmark1) Runding med radius styret af styret af kurve

Driving curve#DTU Management Engineering, Technical University of Denmark

Udvlgelse via DetailsDefault resultat2) Runding af n kant

#DTU Management Engineering, Technical University of Denmark2) Runding af n kant

Transition 1 up to reference (DTM1)Transition 2 Case 1

Eller naturligvis begge transitions#DTU Management Engineering, Technical University of Denmark3) Runding af to kanter med forskellig radius

Default: intersect

Intersect at surface side 1 (one side)Intersect at surface side 2 (one side)

#DTU Management Engineering, Technical University of Denmark3 Runding af to kanter med forskellig radius

Intersect at surface side 1/2 (two side)

Surface of intersectionDTM2#DTU Management Engineering, Technical University of Denmark3 Runding af to kanter med forskellig radius

en conic parameter

to transition lengths L1 og L2

to tilpasningsdiametre D1 og D2

#DTU Management Engineering, Technical University of Denmark4) Runding af tre kanter med forskellig radius

Defautl: intersect#DTU Management Engineering, Technical University of Denmark4) Runding af tre kanter med forskellig radius

Round only one

Round only two

Round by patch #DTU Management Engineering, Technical University of Denmark4) Runding af tre kanter med forskellig radius

Corner sphere + two transition surf. + three transition surfaces

#DTU Management Engineering, Technical University of Denmark4) Runding af tre kanter med ens radius

#DTU Management Engineering, Technical University of Denmark5) Referencer fra ProE Help-memnuen

Round Types and References

About Round transitions

#DTU Management Engineering, Technical University of DenmarkNr standard lsningerne ikke slr til

#DTU Management Engineering, Technical University of Denmark1) round & style p LEGO-arm

Style surfaceOriginalround#DTU Management Engineering, Technical University of Denmark2) warp

Two warp-operationsSingle warp opersation#DTU Management Engineering, Technical University of DenmarkHelmet design using warp ?

#DTU Management Engineering, Technical University of DenmarkKonklusion

Rundinger kan udfres/udformes p mange mder

2) Rundinger kan bruges som modelleringsvrktjer

3) Reparation af standardrundinger kan ved fordel laves ved en kombination af rundinger som surface og style-surfaces

4) WARP-legetjet kan lave ting hurtigt som det ellers er en krig at fremstille ved andre metoder.

#DTU Management Engineering, Technical University of Denmark