PEUGEOT 206+ (2009 - 2011) MKi + CK (EN_US).pdf

207 206+

This sheet is designed to help you with the installation of a Parrot product and is provided purely for information purposes. The installer is solely responsible for any installation carried out in accordance with the instructions in this sheet and for the quality of the installation. All rights reserved © Copyright 2011 PARROT SA, a French Société Anonyme (Public Limited Company) Registered on the Paris Trade and Companies Register under No. 394 149 496 Reproduction not permitted without authorisation from Parrot SA. Images not contractually binding.

206+

Installation manual: Parrot MKi + Parrot CK3100 range

The brand name PEUGEOT 206+ and the PEUGEOT logo are the property of AUTOMOBILES PEUGEOT. This document is only valid for the vehicle model 206+® year 2009 to 2011, excluding all other models in the same range and excluding later modifications made to the vehicle by the manufacturer. The Parrot brand name and logos are the exclusive property of Parrot SA.

207 206+


Accessories required

Disassembly 20min

Kit installation 30min

Refitting 20min

Testing 15min

Total 1h25min

YES ACC wire

YES ISO

YES UNIKA

FRONT SPEAKER TEL mode

ALL MUSIC mode

Fitting time (estimated) / Main features

Tools

- TORX screwdriver

- Multimeter or Test lamp

- Hose clamp

- Electrical tape

- Round file (or a knife)

"Please contact your Wholesaler to purchase accessories."

Kram ref. Dealer ref.

CK range N/A 9706 AR

MKi range N/A 9706 AR

Photos not contractually binding

CK range MKi range

Updating

Plastic trim removal tools FACOM / BERNER

FACOM Sleeve DX-25 (n°4 spanners)

To get the most out of your hands-free kit we recommend that you update your software regularly. The update procedure can be found at

www.parrot.com/usa/support/downloads

http://www.parrot.com/uk/support/downloads

207 206+


Disassembly

207 206+


6

1 2

Disassembly 1 / 2

Insert the removal tools into the slots on each side of the radio.

Unclip, pull and remove the radio taking care to unplug

the connector and the antenna.

Using the plastic trim tools, unclip the air vent surround. Remove screws 1 and 2.

1

3

2

4

5

Using the plastic trim tools, unclip the front without

removing it.

Using the plastic trim tools, unclip the clip located on the left

side of the dashboard.

207 206+


Remove the door seal on the driver’s side.

8

Release the fuse box cover.

7

Disassembly 2 / 2

207 206+


Microphone passage

Stick the bracket supplied after cleaning the surface, to the

windscreen and run the cable under the headliner towards the

driver's side door.

Run the cable replacing the seal on the driver's side door.

Pass the cable into the dashboard on the left and into

the fuse box.

Run the cable towards the radio, attaching it under the dashboard

with wire ties.

1

3

2

4

207 206+


Feeding the accessory cable

In the glove box, unclip the RCA connection support and

disconnect it.

Using a knife or drill, make a notch on the back of the support.

1 2

Pass the cable from the hole towards the radio.

Reconnect and re-fit the cover leaving a sufficient length of

cable.

3 4

207 206+


Fitting the hands-free system 1 / 2

Connect the factory connector or the 9706 AR for CK/Mki. Connect all the cables to the blue box as shown in the diagram below. Test the

assembly before reassembly, then slide all the cables to the left of the radio.

1

ISO adapter

207 206+


Fitting the hands-free system 2 / 2

Stick the support supplied to the display panel after having cleaned

the surface.

Run the cable between the panel and the dashboard towards the

radio.

Replace screws 1 and 2.

2

4

3

Clip the display panel and its surround back on. (Ensure that you

DO NOT cut the cable.)

4

!

207 206+


Testing

Before refitting the system, switch the kit on using the ignition. (or by starting the car) By pushing the central knob

of the remote control, check:

1 - That the menu is displayed on the screen. (Language or iPod.) 2 - That the system can be muted. (Click on the blue box.) 3 - That there is no sound coming from the speakers. 4 - That the sound from the voice menu is coming out of the front speakers. 5 - Then turn off the ignition, check that the kit switches off and that the "goodbye" message appears on the screen. (If this fails, reverse the fuses on the kit's wiring harness.) 6 - Pair a telephone with the kit to make a call. (Check that both the microphone and the kit are working.)

207 206+


Reassembly

Refit the system using the following procedure: 1 – Re-install the radio reconnecting the adapter and antenna. 2 – Re-fit the fusebox cover by pushing hard. 3 – Re-fit the panel on the left-hand side of the dashboard.

Documents

PEUGEOT 206+ (2009 - 2011) MKi + CK (EN_US).pdf