●

●

●

●

Page 1

Thank you for purchasing the MRX-4SEN2 Sensor Extender. Expand yourMRX-Advanced Network System Controller sensor coverage by addingadditional MRX-4SEN2 units throughout the home or office. Takeadvantage of the networking capabilities and control your MRX-4SEN2 viaWi-Fi or wired connection.

● The MRX-4SEN2 utilizes the network (wired or wireless) for a more stable communication to the Total Control System that is less susceptible to interference and more reliable. This grants you the flexibility to install it virtually anywhere in the project.

● Add one or more MRX-4SEN2 throughout you system to add more triggers to your connected home. This may be used to initiate system events in Total Control.

● The small size of the MRX-4SEN2 allows it to easily fit behind equipment or into places where a traditional base station would not.

The MRX-4SEN 2 Includes:

1 -Mounting Plate1 - Owner’s Manual

1 - MRX-4SEN2 Sensor Extender1 - AC Power Adapter4- Mounting Screws

Page 2

Front PanelThe front panel consist of three indicator lights:

Illuminates red when connected to power.

The LED color varies depending on the device’s Wi-Fi connection:

● Illuminates green● Illuminates orange● Not illuminated

This LED flashes as the MRX-4SEN2 transmits data to the MRX Advanced System Controller.

Page 3

Rear PanelThe rear panel consist of:

Plug in the included 5V DC 1A power supply.●

Use only with EN60950-1 approved as Limited power source and double insulation marked power adaptor & same ratings described on the product label ( ).

Connect the sensor’s 3.5mm plug to an available port. The following URC sensors, with their respective model numbers, are compatible with the MRX-4SEN2:

● Voltage Sensor SEN-VOLT● Video Sensor SEN-VID● Contact Closure Sensor SEN-CCLS● Light Sensor SEN-LITE● Current Sensor (Magnetic Field) SEN-CMF● Audio Sensor SEN-AUD

If a wired connection is needed, this port uses a standard Ethernet (RJ-45) plug to communicate via the local area network (LAN).

Page 4

Bottom Panel

The bottom panel consists of:

The serial number, located at the bottom of the unit, uniquely identifies the product.

The MAC Address (12 numbers) identifies this device when connected to the network.

Functions with other wireless devices (routers, wireless access points, etc.) to provide a simplified method of connection to the network. Press this button in conjunction with the WPS button found on your other wireless devices to establish a connection.

Turns the unit OFF then ON again and reconnects to the network.

Page 5

Before proceeding, a Custom Professional is required to installand configure you MRX-4SEN2.

Connect the 3.5mm sensor plug to the rear of the MRX-4SEN2. When achange in the sensor’s state is detected, the MRX-4SEN2 sends a signalto the MRX Advanced System Controller and triggers a series ofcommands.

The example below showcases a voltage sensor connected to the home’sdoorbell and the MRX-4SEN2. Whenever the doorbell is pressed, a signalis sent over the network (wired or wireless) to the MRX Advanced SystemController. The MRX unit, previously programmed by the CustomProfessional, triggers a series of commands or an event to gain yourattention. A programmed event, such as Watch Movie/TV, may pause themovie, mute the audio, and display the front door’s video camera.

Page 6

Wireless Setup

The key feature added to the MRX-4SEN2 is adding Wi-Fi connectivity to an already brilliant sensor expander. Wi-Fi connection makes it simple to install the device in difficult to reach locations of the home.

Steps:

Go to and select

Page 7

Fill out the wireless network information in the window, when finished select

3. Press located below

4. Select from the sub menu in Step 6

5. Discover the MRX-4SEN2 (if you have not already) using themethod for all other URC network devices

Page 8

Highlight the MRX-4SEN2 and double-click on the area thatreads

7. Select via Network

Page 9

8. Unplug the Ethernet cable from the back of the MRX-4SEN2unit.

Page 10

Universal Remote Control, Inc. (“URC”) warrants that URC equipmentpurchased directly from URC or from an authorized URC dealer ordistributor shall be free from defects in material and workmanship undernormal usage for a period of one (1) year from the date of purchase ofthe product by the end-user, but no longer than thirty-six (36) monthsfrom the date of shipment of the URC equipment by URC to an authorizedURC dealer or distributor, except that with respect to Total Control®whole-house products, the warranty extends for two (2) years from thedate of purchase by the end-user, but no longer than forty-eight (48)months from the date of shipment of the URC equipment by URC to anauthorized URC dealer or distributor.

URC warrants that the software will substantially conform in any materialrespect to its functional specifications at the time of delivery. URC SHALLNOT BE LIABLE FOR OPERATIONAL, TECHNICAL OR EDITORIAL ERRORSAND/OR OMISSIONS MADE IN THE URC DOCUMENTATION. URC DOES NOTWARRANT THAT THE URC SOFTWARE IS BUG-FREE OR ERROR FREE ORTHAT THERE ARE NO ERRORS/BUGS IN THE URC SOFTWARE.

URC warrants that at the time of purchase the URC equipment and theURC software complied with all applicable regulations and policies of theFederal Communications Commission ("FCC") regarding electromagneticinterference caused by electronic/computing devices and to the extentthat the URC equipment and/or the URC software fails to so comply, URCshall, at its own expense, take all reasonable measures to promptly causesuch to comply.

THIS LIMITED WARRANTY DOES NOT COVER TECHNICAL ASSISTANCE FORHARDWARE OR SOFTWARE USAGE EXCEPT AS EXPRESSLY PROVIDED FORHEREIN.

Page 11

CERTAIN IMPLIED WARRANTIES, INCLUDING AN IMPLIED WARRANTY OFMERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, MAY BEAVAILABLE WITH RESPECT TO URC EQUIPMENT. IMPLIED WARRANTIESVARY FROM STATE TO STATE. URC EXPRESSLY LIMITS THESE IMPLIEDWARRANTIES, TO THE EXTENT ALLOWABLE BY LAW, TO THE TIME PERIODSCOVERED BY THE EXPRESS WRITTEN WARRANTIES PROVIDED HEREIN.OTHERWISE AND EXCEPT AS PROVIDED FOR HEREIN, URC EXPRESSLYDISCLAIMS ALL WARRANTIES, EXPRESS, STATUTORY OR IMPLIED, ANDMAKES NO REPRESENTATIONS REGARDING THE USE OF, OR THE RESULTSOF THE USE OF, THE EQUIPMENT, SOFTWARE OR DOCUMENTATION INTERMS OF CORRECTNESS, ACCURACY, RELIABILITY OR OTHERWISE.

EXCEPT AS EXPRESSLY PROVIDED FOR HEREIN, TECHNICAL SERVICES ARESUPPLIED "AS IS", WITHOUT ANY WARRANTY, EXPRESS, STATUTORY ORIMPLIED, OF ANY KIND. TO THE MAXIMUM EXTENT PERMITTED BYAPPLICABLE LAW, URC EXPRESSLY DISCLAIMS ALL WARRANTIES RELATINGTO TECHNICAL SERVICES, EXPRESS, STATUTORY OR IMPLIED, INCLUDINGBUT NOT LIMITED TO THE WARRANTIES OF QUALITY OR REASONABLESKILL AND CARE, OR OUTCOME OR RESULTS.

WITHOUT IN ANY WAY LIMITING THE GENERALITY OF THE OTHERPROVISIONS HEREIN, THIS LIMITED WARRANTY DOES NOT COVER: (I)DAMAGE FROM MISUSE, NEGLECT OR ACTS OF NATURE, (II)MODIFICATIONS, (III) INTEGRATION WITH THIRD PARTY CONTENT, OR (IV)BEYOND THE WARRANTY PERIOD AND/ OR FAILURE TO FOLLOW URCWARRANTY CLAIM PROCEDURE.

The warranty limitations and warranty disclaimers may not apply to enduser in whole or in part, where such are restricted or excluded byapplicable law, and such shall apply to the maximum extent permitted byapplicable law.

In the event of any warranty claim, URC will, at its sole option, repair theURC equipment using new or comparable rebuilt parts, or exchange theURC equipment for new or rebuilt equipment.

All the URC equipment returned for service, exchange or repair require anRGA number. To obtain an RGA number, you must complete a Return

Page 12

Request Form which you may obtain by calling (914) 835-4484 orcontacting URC at returnrequest@universalremote.com

. To obtain warranty service, end user must deliver the URC equipment,freight prepaid, in its original packaging or packaging affording adequateprotection to URC at 420 Columbus Avenue, Valhalla, NY 10595. It is enduser's responsibility to backup any macro programming, artwork,software or other materials that may have been programmed into theunit. It is likely that such data, software, or other materials will be lostduring service and URC will not be responsible for any such damage orloss. A dated purchase receipt, bill of sale, installation contract or otherverifiable proof of purchase is required. For the URC equipment supportand other important information, please visit URC's website available atwww.universalremote.com or call the Customer Service Center at (914)835-4484.

This limited warranty only covers the URC equipment issues caused bydefects in material or workmanship during ordinary consumer use. Itdoes not cover product issues caused by any other reason, including butnot limited to product issues due to commercial use, acts of God, third-party installation, misuse, limitations of technology, or modification of orto any part of the URC equipment. This limited warranty does not coverthe URC equipment sold as used, as is, refurbished, so called "B stock" orconsumables (such as batteries). This limited warranty is invalid if thefactory applied serial number has been altered or removed from the URCequipment. This limited warranty specifically excludes the URCequipment sold by unauthorized resellers.

With the exception of URC's IR-only, broad-based consumer remotes,none of URC's PC programmable remotes or any of our Total Control®whole-house equipment are authorized for online Internet sales. BuyingURC's PC programmable remotes or any of our Total Control® whole-house equipment online means buying equipment that does not haveURC's limited warranty. Such equipment is not eligible for URC techsupport or software support, either.

Page 13

IN NO EVENT SHALL URC BE LIABLE FOR INDIRECT, SPECIAL, INCIDENTAL,EXEMPLARY, PUNITIVE OR CONSEQUENTIAL DAMAGES OF ANY KIND ORLOSS OF PROFITS OR BUSINESS OPPORTUNITY, EVEN IF URC IS ADVISED OFTHE POSSIBILITY OF SUCH DAMAGES.

IN NO EVENT SHALL URC BE LIABLE FOR LOSS OF OR DAMAGE TO DATA,COMPUTER SYSTEMS OR COMPUTER PROGRAMS.

URC'S LIABILITY, IF ANY, FOR DIRECT DAMAGES OF ANY FORM SHALL BELIMITED TO ACTUAL DAMAGES, NOT IN EXCESS OF AMOUNTS PAID BYEND USER FOR THE URC EQUIPMENT.

IN NO EVENT SHALL URC BE LIABLE FOR ANY EVENTS BEYOND ITSCONTROL, INCLUDING ANY INSTANCE OF FORCE MAJEURE.

IN NO EVENT SHALL URC BE LIABLE FOR THE ACTS OR OMISSIONS OF ENDUSER OR ANY THIRD PARTY.

THE LIMITATIONS OF LIABILITY MAY NOT APPLY TO END USER IN WHOLEOR IN PART, WHERE SUCH ARE RESTRICTED LIMITED OR EXCLUDED BYAPPLICABLE LAW AND SUCH SHALL APPLY TO THE MAXIMUM EXTENTPERMITTED BY APPLICABLE LAW.

URC SHALL NOT BE HELD RESPONSIBLE FOR THE STATEMENTS MADE BYOTHERS.

SOME STATES OR JURISDICTIONS DO NOT ALLOW THE EXCLUSION ORLIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, OR ALLOWLIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THEABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO END USER. THISLIMITED WARRANTY GIVES END USER SPECIFIC LEGAL RIGHTS AND ENDUSER MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE ORJURISDICTION TO JURISDICTION.

The terms and conditions of the End User Agreement available atwww.universalremote.com/eua.php shall apply.

Page 14

This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the FCC Rules. These limitsare designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, usesand can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference willnot occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouragedto try to correct the interference by one more of the following measures:

❑ Reorient or locate the receiving antenna.❑ Increase the separation between the equipment and receiver.❑ Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.❑ Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the manufacturercould void the user's authority to operate the equipment.Note: The manufacturer is not responsible for any Radio or TVinterference caused by unauthorized modifications to this equipment.Such modifications could void the user's authority to operate theequipment.

This device complies with Part 15 of the FCC Rules. Operation is subjectto the following two conditions: (1) this device may not cause harmfulinterference, and (2) this device must accept any interference received,including interference that may cause undesired operation.

Page 15

Any changes or modifications not expressly approved by the partyresponsible for compliance could void the authority to operateequipment.

The device and the antenna for this device must be installed to ensure aminimum separation distance of 20 cm more from a person's body. Otheroperating configurations should be avoided.

●

●

●

●

Symbol explanations

DISPOSAL. Do not use household or municipal waste collectionservices for disposal of electrical and electronic equipment. EUcountries require the use of separate recycling collectionservices.

DIRECT CURRENT.

Page 16

Page 17