Hardware Redundancy

Dimensions (H x W x D mm)

Weight

Temperature

Humidity (non-condensing)

Power Supply

Maximum Power Consumption

PRODUCT SPECIFICATIONS SUMMARY

© 2009 NEC Corporation NEC and the NEC logo are registered trademarks of NEC Corporation.

For inquiries, contact URL http://www.nec.com/

Cat.No. F02-10010004E

MPLS-TP FEATURES TIMING / SYNCHRONIZATION

NETWORK PROTECTION

NETWORK MANAGEMENT

STANDARDS & RECOMMENDATIONS

Packet Processing Capacity

Maximum ports per chassis

44Gbps full duplex switching

GE/FE x 22ATM/SDH STM-1 x 2E1/T1 x 16 (48 future release)POS STM-1 x 210GE x 2 (future release)

88Gbps full duplex switching

10GE x 4, GE x 40, FE x 24ATM/SDH STM-1 x 8E1/T1 x 16POS STM-64/STM-16/STM-1 x 4

108Gbps full duplex switching

10GE x 6, GE/FE x 36ATM/SDH STM-1 x 64E1/T1 x 64POS STM-64/STM-16/STM-1 x 6

Product MN5100 MN5200 MN5300

・The company names and product names given in this catalog are trademarks or registered trademarks of the respective companies.・The con�guration or speci�cations are subject to change without prior notice due to continual improvements.

＊Before installing, connection or using this product, be sure to carefully read and observe the cautionary and prohibited matters provided in the instruction manual.

Safety Precautions!

• FE/GE/10GE: Sync. Ethernet, 1588v2, Line timing and SSM

(control frame) transmission

• POS: Line timing and SSM (S1 byte) transmission

• Free run: ±4.6ppm (ITU G.813)

• Holdover: ±0.05ppm (Better than ITU G.813) within 24h

• Sync signal for 3G Base Station: External timing output

• Traceable STM-1 ATM interface as line timing source

• Provide 1pps+tod time input and output (MN5100)

•RFC 3031, 3916, 3985, 4197, 4553, 4842, 4717, 4816, 4448

•ITU-T G.8110, G.8110.1, Y.1711, Y.1720, Y.1731

•IEEE 1588v2, 802.1ag, 802.3ah

SpectralWave MN9200, LCT (Local Craft Terminal)

• 1+1 Linear MSP (G.841 Annex B) for STM-1 (ATM/SDH)

• 1:1 Linear MSP for STM-1 (ATM/SDH)

• 1+1 and 1:1 Linear protection for LSP

• Ring protection (future release)

Power input

44.5 x 440 x 245 (1U)

4kg (full)

0℃ to 50 ℃

5% to 95%

50W (fully loaded)

133 x 440 x 410 (3U)

21kg (full)

-48V DC

300W (fully loaded)

320 x 440 x 410 (7U)

41kg (full)

700W (fully loaded)

Power unit, OAM/Clock/Switch fabric, E1/T1 card protection

5 ℃ to 40 ℃

5% to 85%

Published by NEC Corporation Global Network Division

MN5100

PACKET TRANSPORT NETWORK SOLUTION

http://www.nec.com/

MPLS-TP PACKET TRANSPORT SOLUTIONFOR MULTI-SERVICES

• 8K MPLS label per MN5200/MN5300, 4K per MN5100.

• E-LSP and L-LSP support

• Per platform Label space support

• Bi-directional and Uni-directional MPLS-TP trail

• DiffServ support

2 service levels for TDM (E1/T1, SDH/SONET),

4 service levels for ATM,

8 service levels for Ethernet

• MPLS OAM including protection switching

• VCCV, LSP Ping/TraceRoute

• EMS/SNMS manual control of PW/LSP setup/release

MN5000-series

MN5000-series

®

MN5200 MN5300

NETWORK MANAGEMENT

The MN5000 is a new packet transport product based on pseudowire

over MPLS-TP technology; it has been developed to overcome the

data traf f ic consuming at most carrier’s bandwidth in current

SDH/SONET based infrastructure. As a convergence transport tech-

nology, the MN5000 is the key fact for today’s metro network carriers

and services providers. Equipped with enhanced data service

processing capability and powerful network management function,

the MN5000 can provide all-round network solutions at the access

layer and aggregation layer of a Metropolitan Area Network (MAN),

enormously reducing the operation cost. Operation cost is optimized

by both MN5000 and MN9200 because of simple and easy OAM of

Packet Transport Network.

The MN9200 is a comprehensive Network Management System for

operating the MN5000, and features an integrated broad set of func-

tions ready for the growing demands on packet transport system, and

provides an integrated network management visibility and control of

various customers network and/or regions on a sophisticated graphi-

cal user interface (GUI); designed specifically to incorporate the most

required features and best practices of the leading telecommunica-

tion carriers, the GUI is user friendly, simple and practical. The

MN9200 continuously evolves to support the state of the art on man-

agement capabilities, meeting all the customer needs on packet trans-

port network.

The MN9200 provides all necessary service configuration tools of

LAN / WAN / ATM / PDH connection establishment.

The LSPs/PWs (path) can be easily created from A to Z and/or discov-

ered at the network through a state-of-the-art search mechanism,

allowing the operator to easy introduce and manage the services avail-

ability on the network.

The MN9200 supports performance monitoring for ATM, PDH, SDH,

Ethernet, Pseudowire and LSP, and also supports Graphical PM

report and browsing manually and automatically.

The MN9200 supports advanced alarm monitoring functions such as

Current Alarm Monitoring, History Alarm Statistics, LSP/PW/CE

Service alarm, Network Equipment (NE)/Board/Port alarm, Communi-

cation alarm, Clock alarm, External Environment alarm, and so on.

The MN9200 supports powerful QoS provisioning mechanism. It is

possible to create a guaranteed connection by each individual service

type within its corresponding layer (LSP, PW and CE).

In despite of its End-to-End (E2E) services QoS provisioning, the

operator can manage each equipment individually for its services,

units and ports for implementation and/or troubleshooting.

The MN5000 suits for Metro Ethernet service, Mobile Backhaul,

DSLAM & xPON Aggregation, SDH network migration, and so on.

The MN5000 supports Ethernet over MPLS, Circuit emulation over

MPLS and ATM over MPLS, and can carries TDM, ATM and Data

traffic through managed path, over Pseudowire and LSP layer in

MPLS-TP network. ATM IMA is planned.

The MN50 0 0 suppor ts s t rong OAM fea tu res; MPLS - OAM,

Pseudowire OAM, SDH OAM, ATM OAM, and Ethernet OAM, useful

for connectivity verification, fast failure detection, tracing and so on.

● Co-existence with SDH Network● Interoperability with existing IP/MPLS core

● MPLS and Carrier Ethernet based QoS● Residential and Enterprise traffic can co-exist while guaranteeing

the SLAs.

SOLUTIONS EXAMPLE

PRODUCT OVERVIEW

KEY BENEFITS

APPLICATIONS

MN5000 KEY FEATURES

● All the services come from single network● State art pure-packet architecture

Cost Effective Network

The MN5000 can bring in following key benefits.

Ease of Operation

New Revenue Generating Services

Multi-services transport with path management

Operation and Maintenance (OAM) Features

The MN5000 supports high speed protection less than 50ms. It

ensures carrier grade continuous services.

Network Protection

Key Functions of Management, Operation and Maintenance

The MN5000 supports high performance Synchronization Distribution

over packet transport network, suits for mobile backhaul and so on.

Timing Synchronization

Quality of Services

Mobile Backhaul Solution Metro Ethernet Solution

QoS Provisioning

Service Configuration and LSP/PW (Path) Provisioning

Performance Monitoring

Fault and Alarm Monitoring

Guaranteed SLAs

Smooth Migration

● User friendly GUI for all the standard operation● Minimal training of personnel, reuse of existing skill-set● Simple Architecture (Connection oriented, Deterministic data plane)● Static provisioning (plan for dynamic provisioning)● Standards based enhanced OAM (Advanced troubleshooting)● Powerful network management with End-to-End provisioning

(Hides the complexity of MPLS protocol)● Separated Control-plane and User-plane

(Network stability behavior advantage)

● MEF 9 and 14 certified● Enables new enterprise services such as VPL, EVPL, TLS, and so on● Quick creation and activation of new services● Supports VLAN and Multicast

● Smooth and cost-effective migration from 2G to 3G● Advanced QoS for E2E connection and protection (<=50ms)● Single powerful E2E management system for 2G and 3G

transport network● Forward-looking approach for All-IP evolution with cost saving

● Simply managed path on MPLS-TP network carries traffic

to/from IP/MPLS core network.● VPN services for enterprise customers; E-Line/E-LAN/E-Tree● Advanced QoS and protection guarantee SLAs.● User friendly management system enables quicker service delivery.

● System resources● Secure the network against unauthorized access● Resource inventory management● Simple analysis of network capacity

● Network provisioning● Search, discover and activate NE, Physical/Digital Link● Introduction of new NE without services interruption● Manage Linear Section Protect (LSP), Pseudowire (PW),

Customer edge equipment (CE), neighborhood information

● Network operational status● Help tools to provide service restoration and assurance against failure● Performance data and analyzes on both table and graphical view

The MN5000 implements the latest QoS aware bandwidth control,

queuing, policing and scheduling techniques. It supports MPLS

based QoS for TDM, ATM and Ethernet Traffic based on E-LSP and

L-LSP, and low latency real-time services as well as best-effort data

services with tunable performance requirements. The MN5000

supports DiffServ with minimal adjustments to the MPLS and DiffServ

architectures, and introduces traffic-management and congestion

avoidance mechanisms to condition and implement the different

class and drop precedence for traffic.

ClientEquipment

ClientLayer

PseudoWire

UplinkLayer MPLS-TP

OpticalLink

GE/2.5G/10G

LSP1

LSP2

LSP3

PW1～PWn

1000M50M30M

PW-A

Ethernetover MPLS

CircuitEmulation

ATM overMPLS

FE/GE/10GE

E1/T1/STM-N

ATM STM-1

L2/3switch

SDH/PDH

ATM

MN5000-series

3G NodeB orLTE eNodeB

3G NodeB

3G NodeB

2G BTS

Cell Site Mobile Backhaul Mobile Core Network

T1/E1(Copper)

ATM(IMA/STM-1)

Ethernet(Fiber,GPON,xDSL)

MN5000MN5000

MN5000

MN5000

Any traffic overMPLS-TP

STM-1

ATMSTM-1ch

GbE/10GbE

BSC

RNC

aWG

Operator’sCircuit SwitchingBackbone Network

Operator’sPacket SwitchingBackbone Network

A1

B1

B4C3

B2

A2B5

B3

C1 C2

MPLS-TPMetro

MPLS-TPMetro

MPLS-TPMetro

MPLS-TPMetro

IP/MPLSCoreCity-1

POP

MN5000

MN5000

GE/10GE

MPLS-TPCarrier Class DesignSimple Operation