Millipore DI Water Purifier

Ron Kmak, Zeljko Matijas, Laura Skubal, Dean Walters, and Bob Wagner

28 September 2011

Timeline of events• 28 April 2011 first discussion of water purifier• 26 May 2011 specification of purifier settled on.• Discussion of Millipore versus Crossbow purifiers• 28 June 2011 Millipore quotation distributed.• 7 July 2011 demonstration by Millipore of DI purifier• 19 July 2011 requisition entered into the purchasing system• 22 August 2011 Millipore enters order into their system.• 8 September 2011 Millipore system arrives• 15 September 2011 wall brackets mounted on wall• 22-23 September 2011 check out parts fit-up• 27 September 2011 Millipore installs unit & trains staff

Planning

• The DI Water Purifier has been planned for the south west corner of the Wet Lab (C-248).• This location facilitates DI water consumption in both the Wet Lab and the Photocathode

Lab

Quotation

• The Millipore Integral 10 system was sized to have the capacity and the flow for the anticipated needs of the Wet Lab.

• The Integral 10 comes with (2) type 1 water dispensers, ultra pure, and (1) type 2 water dispenser, pure water.– It was noted that SSL uses type 1

water to clean their parts.– The APS clean line uses type 2 water

to clean parts for vacuum usage.

Installation Preparations

Blank Canvas

BracketLocations

Ready for Installation

Installation by Millipore

John HalloranMillipore Corp.

Complete

Future Tasks

• Dispenser in Photocathode Lab– Cut hole into wall between Wet and Photocathode

Labs.– Need either table or shelf for the MilliQ (type 1)

dispenser.• Fume hood dispenser– Need table or shelf for the MilliQ dispenser– Install feed tube for filling the Citranox or rinse

tanks.