Matthew Dysinger

17839 Kafir Road

Carthage, MO 64836

417-793-3600

mdysinger3@sbcglobal.net

Position: CNC Machinist, Programmer, Setup and Maintenance/Supervisor

Experience:

+20 years in the CNC field CNC Setup

CNC Programming CNC Maintenance

CNC Supervisor CNC Personnel Training

Quality Control Job Scheduling

Metal Fabrication Tooling Management

Personal Assets:

Mechanically Inclined Self-Starter

Dependable Goal Oriented

I have extensive knowledge of CNC production. I’ve built CNC departments from the ground up. This includes setting machines in place and organizing the entire area. I manage job efficiency and ensure parts are running at maximum profitable times and quality and exercising safety. I’ve taken several parts from non- profitable to highly profitable.

Education and Training:

1981-1985 Jackson High School Jackson, MO

1990 Acquired GED MO

1987-1994 Army National Guard-Honorable Discharge Carthage, MO

1992-1993 Franklin Technical School Joplin, MO

• A/C Refrigeration

• Auto Body Repair

1999 Mazak Incorporated Florence, KY

• CNC Machine Repair

Work History:

2003-Current Fasco Machine Works Joplin, MO

Duties include:

I setup and run parts, as well as supervise and train other machinist. I ensure all parts are being manufactured per customer’s request and in the time allotted. I order tooling needed for current and future jobs. I am very fluent in EIA and Mazatrol programming. I also prove and correct programs that are created in Mastercam. My department currently consists of three vertical mills and two horizontal mills with fourth axis. I also perform maintenance on our machines, which includes spindle replacements, servo motors and troubleshooting drives and tolerance specs. I typically decide how parts are to be set up and fixtured.

1996-2003 Leggett & Platt, Inc Carthage, MO

Duties Included:

I setup and ran parts, as well as supervised and trained other machinist. I ensured all parts were manufactured per customer’s request and in the time allotted. I ordered tooling needed for current and future jobs. I ran Mazak Horizontal machines and built a palletech system. I was sent to Mazak in Florence, KY for mechanical repair of machines. I also performed maintenance on our machines, which included spindle replacements, servo motors and troubleshooting drives and tolerance specs. I typically decided how parts were to be set up and fixtured.

1991-2003 Cardinal Scale Manufacturing Webb City, MO

Duties included:

I setup and ran parts on CNC and manual machines for the scale industry. I built various racks and crane systems for the machine shop. I also worked on building additions and building maintenance.

Special Interests/Hobbies:

Private Pilot

Auto Restoration