Lab4 – Configuring Basic Router Settings Topology Addressing Table Device Interface IP Address Subnet as! Default "ate#ay R1 G0/0 192.168.0.1 255.255.255.0 N/A G0/1 192.168.1.1 255.255.255.0 N/A PC-A NIC 192.168.1.3 255.255.255.0 192.168.1.1 PC-B NIC 192.168.0.3 255.255.255.0 192.168.0.1 $b%ectives Part &' Set (p t)e Topology and Initiali*e Devices • Cable equipment t mat!" t"e net#$% tpl&'. • Initiali(e an) $e*ta$t t"e $ute$ an) *#it!". Part +' Configure Devices and ,erify Connectivity • A**i&n *tati! IP +, in$matin t t"e PC in te$a!e*. • Cni&u$e ba*i! $ute$ *ettin&*. • e$i' net#$% !nne!ti+it'. • Cni&u$e t"e $ute$ $ . Part -' Display Router Infor.ation • Ret$ie+e "a$)#a$e an) *t#a$e in$matin $m t"e $ute$. • Inte$p$et t"e utput $m t"e *ta$tup !ni&u$atin. • Inte$p$et t"e utput $m t"e $utin& table. • e$i ' t"e *tatu* t"e inte$a!e*. Part 4' Configure IPv/ and ,erify Connectivity Part 0' Configure Router to Allo# CCP Access Part /' 1$ptional2 Install and Set (p CCP on PC3A Part ' Configure R& Settings (sing CCP Part 5' (se CCP (tilities 2013 Ci*! an)/$ it* ailiate*. All $i&"t* $e*e$+e). "i* )!ument i* Ci*! Publi!. Pa&e & &6
