Kiln erectionErection and alignment of kiln bases and gearbox supportsPreassembly of kiln shell heavy sections (tyre sections)Preparation of Kiln bearings, scraping if necessaryErection and alignment of bearings, rollers and thrust deviceErection of kiln drivePreassembly of kiln light sectionsErection of kiln heavy and light sections, alignment and weldingErection of kiln seals, heat shields, fans, etc.
Erection and alignment of kiln bases and gearbox supports
Alignment of kiln bases
Gear box supports and self aligning yoke
Preassembly of kiln heavy sectionsMark up and weld on one side of retainers
Insert tyre, mark up and weld next sideAlign tyre to shell and weld on axial retainersAll welding are to be inspected by UT and MT
Mounting of tangential suspension
6Preparation of kiln bearingsCheck with blue marking, and scrape if nesseary
Erection and alignment of bearings, rollers and thrust deviceErection and alignment of bearings and rollers
Erection and alignment of thrust device
Erection of kiln drive
Preassembly of kiln light sections and erection of kiln
Kiln seals, heat shields, fans, etc.
Animation of the Rotax- 2 kiln