29
JIF 314 Thermodynamics Chapter 7 The Carnot Cycle and the thermodynamic temperature scale

JIF 314 Thermodynamics

Embed Size (px)

DESCRIPTION

JIF 314 Thermodynamics. Chapter 7 The Carnot Cycle and the thermodynamic temperature scale. Conversion of work into heat and vice versa. Consider a heat engine. A heat engine is one that turns heat into work in a cyclic manner. - PowerPoint PPT Presentation

Citation preview

Page 1: JIF 314 Thermodynamics

JIF 314Thermodynamics

Chapter 7

The Carnot Cycle and the thermodynamic temperature scale

Page 2: JIF 314 Thermodynamics

Conversion of work into heat and vice versa Consider a heat engine. A heat engine is one that

turns heat into work in a cyclic manner. The heat engine interacts thermally with the

surroundings, which consists of a high-temperature reservoir, HTR (at constant temperature TH), and a low-temperature reservoir, LTR (at constant temperature TH).

The heat engine system at initial state i absorbs heat by the amount |QH| from HTR, turning part of this heat into work |W|, and the balance of heat,

|QL| =|QH| -|W|, is rejected into the LTR. After the rejection of |QL|, the heat engine’s state will

resume to the initial state i.

Page 3: JIF 314 Thermodynamics

Heat engine operating in a cycle

High-temperature reservoir at TH

Low-temperature reservoir at TL

|W| work is done by system as an output

|QH| is absorbed by system from HTR

|QL| is rejected by system to LTR

state i

Intermediate state m1

Intermediate state m2

Page 4: JIF 314 Thermodynamics

Thermal efficiency of a heat engine At the end of a complete cycle, dU =0 (since the

state of a heat engine returns to its initial one at the conclusion of the cycle)

Thermal efficiency = work output/heat input

H L L

H H H

due to first law

1W Q Q Q

Q Q Q

Thermal efficiency will be 100% only if |QL|=0

Page 5: JIF 314 Thermodynamics

Kelvin-Planck statement of the second law “It is impossible to construct an engine that,

operating in a cycle, will produce no effect other than the extraction of heat from a reservoir and the performance of an equivalent amount of work”

In plain language, it means it is impossible to have a machine that can convert totally all heat absorbed from a HTR into work without rejecting any heat back to the LTR.

The conversion of heat into work must associated with at least certain minimal effect such a rejection of heat into LTR.

Page 6: JIF 314 Thermodynamics

Consequence of Kelvin-Planck statement to heat engine Heat engine could never achieve 100%

efficiency since |QL| can never be zero.

Page 7: JIF 314 Thermodynamics

Example of heat engines: The gasoline engine

6 processes, out of which 4 are ‘strokes’, 2 are heat transfer processes.

Otto cycle describes an idealised gasoline engine Referring to the Otto cycle, the states transition are in

the sequence …12 3 4 5 1… The subsequent states are connected via

thermodynamic equations 51, 1 5, P0V=nRT1

12, adiabatic compression, T1V1T2V2

23, heat absorbed |QH|= 34, adiabatic expansion, T3V2

T4V1

41, heat rejected |QL|=

4

3Vd

T

TC T

4

1Vd

T

TC T

Page 8: JIF 314 Thermodynamics

Figure 6-1

Page 9: JIF 314 Thermodynamics

Thermal efficiency of Otto heat engine

1

2

1T

T

Real gasoline engine would have a much less the efficiency of the idealised Otto engine, which set the upper limit of the thermal efficiency to any real gasoline engine

Page 10: JIF 314 Thermodynamics

Air-standard idealised diesel engine In comparison to gasoline engine, the process 23 of

an air-standard diesel engine is an isobaric heat absorption while the volume expands quasi-statically

23 is a horizontal line in Otto’s while it’s a vertical line in Diesel’s.

4 4 1 1

3 2 2 3

For idealised Diesel Engine,

1 111 1 ;

1

E

E

E

rT T T Vr

T T T Vr

Page 11: JIF 314 Thermodynamics

Figure 6-2

Page 12: JIF 314 Thermodynamics

The steam engine

Figure 6-3(a), 6-3(b)

Page 13: JIF 314 Thermodynamics

The steam engine

Figure 6-3(a), 6-3(b)

Page 14: JIF 314 Thermodynamics

Refrigerator

The reverse of a heat engine is a refrigerator – it absorbs heat |QL| from a LTR by pumping work |W| into the system, and then ejects heat of the amount |QH| to HTR.

For a refrigerator, |QL|+|W|=|QH|

A refrigerator is to extract as much heat |QL| as possible from the LTR to a HTR with the expenditure of as littler work |W| as possible.

Page 15: JIF 314 Thermodynamics

Refrigerator operating in a cycle

High-temperature reservoir at TH

Low-temperature reservoir at TL

|W| work is done on the system as an input

|QH| is rejected by system into HTR

|QL| is absorbed by system from LTR

Intermediate state m1 Intermediate

state m2

State i

Page 16: JIF 314 Thermodynamics

Clausius statement of the second law “It is impossible to construct a refrigerator

that, operating in a cycle, will produce no effect other than the transfer of heat from a low-temperature reservoir to a higher temperature reservoir”

Put in plain language: Heat does not flow spontaneously from a LTR to a HTR. Work is always necessary to transfer heat in such a heat transfer process.

Page 17: JIF 314 Thermodynamics

Equivalence of the Kelvin-Planck statement and Clausis statements Using the language of logics, it can be shown

that both statements are equivalent, i.e. one statement implies the other, and vice-versa.

Read page 156 yourself.

Page 18: JIF 314 Thermodynamics

Definition of reversibility

In practice, all natural process involve conversion of energy from one form to another, W Q U.

A reversible process is one that is performed in such a way that, at the conclusion of the process, both the system and the local surroundings may be restored to their initial states without producing any changes in the rest of the universe.

A process that does not fulfilling these stringent requirements is said to be irreversible.

Example: A system of gas expands and then contracts to its original volume, without any change in the thermodynamic coordinates of the gas system + the that of the rest of the universe. Such would constitute an reversible process.

Question: Are natural processes reversible?

Page 19: JIF 314 Thermodynamics

Most natural processes are not reversible Most representative natural processes are

not reversible Most natural processes, particularly those

macroscopic processes, involves performance of work into internal energy, a process that can be categorised into two classes, as followed:

Page 20: JIF 314 Thermodynamics

Two large classes of processes involving performance of work

1) Isothermal transformations of work done through a system (which remains unchanged) into internal energy of a reservoir. Heat flows through the boundary of the system during such processes. See Fig. 6.9.

2) Adiabatic transformation of work into internal energy of a system. Heat does not flow through the boundary of the system during such processes. See Fig. 6.10.

Page 21: JIF 314 Thermodynamics
Page 22: JIF 314 Thermodynamics
Page 23: JIF 314 Thermodynamics

2nd law of thermo infers non-reversibility in processes involving transformation of work into internal energy Both generic types of processes are not

reversible due to the second laws of thermodynamics.

Read page. 159 Zemansky for the arguments leading to such conclusion.

Page 24: JIF 314 Thermodynamics

Dissipative effect In the processes mentioned previously, (i.e.

processes involves performance of work into internal energy), the conversion of work into internal energy is described as “work is ‘dissipated into internal energy”.

Dissipative effects are necessary to transform work into internal energy of a system. Without these dissipative effects, no transformation of work into internal energy is possible.

Example of dissipative effects: friction, viscosity, inelasticity, electric resistance, magnetic hysteresis.

In most natural process, dissipative effect is always present and it cannot be totally eliminated.

Page 25: JIF 314 Thermodynamics

Dissipative effect (cont.) A generic natural process usually involve the conversion of forms of

energy. In particular, the conversion of energy form from work into internal energy,

Wf = U can only happen in the presence of an agent of dissipation, e.g. friction or viscosity.

Say, consider a moving object with kinetic energy K is subjected to frictional force, f. The force is responsible to dissipate the kinetic energy of the object into internal energy.

The frictional force f, being an agent of conversion, converts the kinetic energy into internal energy: K U.

Should there be no friction, no conversion of kinetic energy into internal energy is possible.

In the conversion of K U, the amount of work done by the force f is equal to the change of the kinetic energy of the object, i.e.

U is the increase of internal energy of the system + that of the environment.

Due to the nature of all dissipative effect, it is not possible to convert all K solely into the internal energy of the system (i.e. the moving object) with no dissipation into ‘the rest of the universe’.

Once dissipated into ‘the rest of the universe’, the energy cannot be recovered in practice for work-performing purpose.

In other words, dissipative effect always contribute to ‘wastage’ of useful energy into some of form of internal energy that cannot be recovered.

K f dr

Page 26: JIF 314 Thermodynamics

All natural processes are non-reversible As a consequence of the pervasive presence of dissipative

effect in all natural processes, which necessarily involve conversion of the form Wf U, exhibit irreversibility.

Such irreversibility due to the presence of dissipative effect is called mechanical irreversibility.

As a conclusion, we revise the logic leading to mechanical irreversibility:

Most representative natural processes involves conversion of work into internal energy.

Dissipative effect is always present in such processes. Hence, these processes exhibit mechanical irreversibility. The statement of 2nd law on macroscopic processes is

closely related to the fact that dissipative effect can never practically be totally eliminated from such processes.

Page 27: JIF 314 Thermodynamics

Perpetual machine of the third kind Imagine an heat machine without any

‘dissipative effect’ of any sort. Such an imaginary machine can convert all

energy into work without any work dissipated into internal energy.

Such an imaginary perpetual machine that has no friction is called ‘perpetual machine of the third kind’.

Page 28: JIF 314 Thermodynamics

Questions to arouse your curiosity What is perpetual machines of the first and

second kind?

Page 29: JIF 314 Thermodynamics

What are the necessary conditions for reversibility? 1) Thermodynamical equilibrium

AND 2) No dissipative effects

Both conditions must be satisfied if reversibility is to be achieved.

It is not possible to satisfied these conditions perfectly in practice

Hence, in nature all processes are irreversible