How to Make an Origami Flower - What Will We Do Today? How to Make an Origami Flower What will we do today? 1. Place the square, design side down, in front of you on a flat surface.

  • Published on
    24-Feb-2018

  • View
    220

  • Download
    5

Transcript

  • www.whatwillwedotoday.com

    What will we do today?

    What you will need:

    Origami Paper (or other paper cut to about 6 by 6)

    Plastic Straw (or paper rolled into straw)

    Hot Glue Gun and Glue Sticks (or other fast drying glue)

    Plastic Ruler or bone knife (to assure sharp crease)

    How to Make an Origami Flower

    Sunday, February 12, 12

    http://www.whatwillwedotoday.comhttp://www.whatwillwedotoday.com

  • www.whatwillwedotoday.com

    How to Make an Origami FlowerWhat will we do today?

    1. Place the square, design side

    down, in front of you on a flat

    surface. It should resemble a

    diamond (not a box).

    2. Fold the bottom edge to meet

    the top edge exactly and crease

    well

    3. Fold the right corner to meet

    the top corner and crease well.

    4. Fold the left corner to meet the

    top corner and crease well.

    5. Open the flaps.

    6. Fold the right side to just meet

    the scored line on the right and

    crease well.

    7. Using the fold as a guide, fold

    over once again and crease.

    Sunday, February 12, 12

    http://www.whatwillwedotoday.comhttp://www.whatwillwedotoday.com

  • 9. Find the little flaps that extend

    beyond the triangle. Fold these

    down to meet the fold and crease

    well.

    8. Repeat Steps 6 and 7 on the left

    side.

    www.whatwillwedotoday.com

    How to Make an Origami Flower

    10. Open the model so that you are

    viewing the original diamond.

    11. Using the creases as a guide, fold

    the right and left flaps over and

    crease.

    12. Using the previously creased

    guides, refold the paper to the

    small diamond from Step #9

    Sunday, February 12, 12

    http://www.whatwillwedotoday.comhttp://www.whatwillwedotoday.com

  • 15. The inside of the petal will look

    like this. Run your finger on the

    inside of the petal to puff it out a

    little bit and flatten any paper

    that may be sticking out.

    13. Put a strip of glue on one edge of

    the flower petal.

    www.whatwillwedotoday.com

    How to Make an Origami Flower

    14. Pinch the edges together without

    creasing the back of the petal.

    16. Make 5 or 6 petals and then put a

    strip of glue on the stem for the

    first petal.

    17. Glue the straight edge of the petal

    to the stem with the pointed part

    of the petal facing down.

    18. Glue the remaining petals on to

    the stem.

    Sunday, February 12, 12

    http://www.whatwillwedotoday.comhttp://www.whatwillwedotoday.comhttp://www.whatwillwedotoday.com

Recommended

View more >