35 0800 RESENE (737 363) www.resene.co.nz

All the colour you need

inside and out!All the colour you need

Simply bring this ad into your local Resene ColorShop and we’ll give you the Resene The Range Fashion Colours fandeck OR your choice of a Resene Testpot 55-80ml FREE!

Limited to one The Range fashion colours fandeck OR Resene Testpot 55ml per advertisement at Resene owned ColorShops only until 30 November 2015 or while stocks last. Limit 1 free item per coupon and household.

free!

Get inspired with The Range fashioncolours fandeck, packed full of the latestdesigner paint colours and complementary colour suggestions for 2015 and beyond. Available now at your local Resene ColorShop or reseller!

ReseneButtercup

ResenePoppy

ReseneRed Berry

ReseneRivergum

ReseneKoru

ReseneCoriander

ReseneWild Thing

diy projectProudly supplied by

34

Rose Hughes shows how to make a simple structure to support climbing beans,

peas or sweet peas

climbingframe

pho

tos:

Ro

se h

ug

hes

1Mark screw holes into the top and bottom panels, making an allowance

for the hinges to the top two panels. Drill and countersink the holes.

2 Lay two of the 1800mm lengths onto a flat surface. Lay two 900mm pieces

across each end to form a rectangle. Put on screw into each corner and, after ensuring that the corners are square, add the second screws.

3Add the additional top and bottom filler panels. Fill the holes, undercoat

then topcoat the two frames.

4 Lay the chicken wire over the outside face of the frames. Pull taut and

attach using a staple gun.

5 If you want to add the decorative edging, measure and mitre the corners

so the architrave edge fits neatly against the outside edge. Undercoat and topcoat then attach with small nails with another top coat to hide the nail heads.

You will need: • 14m of 20mm x 65mm dressed treated pine • 11m of 45mm wide decorative architrave (optional) • chicken wire • 8g x 32mm galvanised screws • 2 x 50mm hinges • small nails • power saw • power drill• staple gun and staples • wire cutters• sandpaper • filler • paint • brushesPaint • undercoat: Resene Quick Dry Primer • topcoat: for the frame pictured left I used Resene ‘Koru’Cutting measurements • Sides: 4 x 1800mm • Top, base and filler: 4 x 900mm and 4 x 770mm • Feet: 4 x 300mmCost: $110 ($80 with no architrave)

materials

6 Lay the two frames outside face down, with the tops touching and screw the

hinges into position. Cut an angle to the bottom of the feet and attach to the inside of the frames at each side. ✤

1

3

5

2

4

6