19
GPS Tracker www.ttbvision.com

GPS Tracker S-Style User Manual V1.1

Embed Size (px)

Citation preview

GPS TrackerUser’s Manual(Version 1.1)

www.ttbvision.com

www.ttbvision.com

Please read this manual carefully before using the tracker. No notice if appearance or color is changed.

www.ttbvision.com

1. Components

Tracker Power cable Sticker

Battery GPS antenna(Optional)

2. Specifications

1) GPS FeaturesChipsets: SiRF Star (GSC3f/LP)ⅢChannel: Paralleled 20 ChannelsSensitivity: < -156dBmTTFF: Cold Start 60s, Hot Start 3sFix Accuracy: 10m

www.ttbvision.com

Speed Accuracy: 0.3m/s2) GSM Features

Band: GSM 900/1800MMaximum Transmission Power: 1W

3) Main FeaturesDimensions: 75mm*52mm*20mmOperating Voltage: 9V ~ 30VMaximum Operating Current: < 800mA(12V)Standard Operating Current: < 10mA(12V)Operating Temperature: -20 ~ +70 ℃ ℃Humility: 20% ~ 95%

3. Outlook and Interfaces

www.ttbvision.com

www.ttbvision.com

Power On/Power Off:When in power-off state, press and hold the key for approximately 3 seconds, it will power on.When power on, press and hold the key for approximately 3 seconds, it will power off.[Note] When connected to an external power supply, tracker will automatically boot. So this key is rarely used.

4. LED Indication

www.ttbvision.com

www.ttbvision.com

1) SIM Card IndicationLED IndicationSolid Blue Power On and SIM card is

OKSlow Blink Power On but SIM card

doesn’t workTurn Off Shutdown

2) GSM Signal IndicationLED IndicationSolid Blue Full(4/4) SignalSlow Blink 3/4 SignalQuick Blink 1/4 ~ 2/4 SignalTurn Off No Signal

3) GPS Signal IndicationLED IndicationSolid Blue Fix successfullySlow Blink Find some satellites but

can’t fixQuick Blink GPS module is working but

can’t find satelliteTurn Off GPS module is shutdown

or fail to work

5. Installing

1) Installing SIM card and batteryOpen SIM card cover, insert SIM card into SIM socket and lock SIM socket. Install the included battery and restore the battery cover.

2) Installing tracker into vehicle

www.ttbvision.com

The tracker is suggested to be installed by professional organizations specified by dealer with following notices:A. To avoid human destruction,the tracker should

be concealed installation. B. Avoid installation near the emission

source, such as reversing radar, and other automobile communication equipments.

C. Avoid high temperature, high humility environment.

D. Avoid the effect of vibration detection by using double-side adhesive or strapping fixed.

E. If GPS antenna is built-in, make sure the front side of the track to face to sky without any metal covering it.

3) Installing power cableA. The appropriate power voltage scope is 9V-30V,

the red line represents for positive power supply and the black line represents for the negative power supply.

B. Please select a separated ground for black line(negative power supply), don’t use same ground with other electrical equipments.

6. User Guide

Proper use of the tracker as follows:Installation → Power on → Binding → Operating (by SMS or Internet)1) Power on

Connected to vehicle power, the tracker will automatically turn on.

www.ttbvision.com

If it can not automatically start, press the “Power On/Power Off” key to boot manually.

2) Binding(must be done, otherwise can not perform other operations)Use a mobile phone sends SMS to the tracker as following format: START, Initial password, New password, Phone number of tracker. Where the Initial password is 123456 and the New Password is a new password set by the user to replace the initial one.[e.g.]START, 123456, 654321, 138XXXXXXXX“138XXXXXXXX” is the phone number of the tracker. After received positive response SMS, the mobile phone’s number has bound with the tracker’s number, user can send following messages through this phone to control the tracker or do those by visiting the web site provided below (refer to 5.A).

3) Operating(by SMS)A. Change password

Use the bound phone to send the following SMS to tracker: START, Current password, New password

B. LocationUse the bound phone to send the following SMS to tracker: POS. The tracker will reply a SMS which describes the current location of the vehicle, such as: near XX Building XX Road XX City XX Province.

C. Latitude and Longitude Location

www.ttbvision.com

Use the bound phone to send the following SMS to tracker: POS2. The tracker will reply a SMS which describes the current location of the vehicle by latitude and longitude, such as: 202.238614, 11.763924.

D. ArmUse the bound phone to send the following SMS to tracker: LOCK. After this, the vehicle will reply alarming SMS when it is moved or vibrated abnormally.

E. DisarmUse the bound phone to send the following SMS to tracker: UNLOCK. When successfully set, the tracker will return to normal state.

4) Warning MessageA. Battery low voltage alarm

As literally means, when the built-in battery’s voltage is lower than a certain value, the tracker will report this to the bound phone by SMS.

B. External power supply removed alarmIt means the tracker was disconnected with the vehicle’s battery.

C. Vehicle moved alarmIt means the vehicle was moved more than a certain distance (e.g. 300m), and maybe was theft. This alarm only is reported when the vehicle was successfully armed (refer to 3.D).

D. Vehicle vibrated alarmIt means the vehicle was vibrated when it was successfully armed. Also, the vibration will lead a SMS reporting.

www.ttbvision.com

Notes

5) The tracker must be installed closely with the vehicle body, so as to ensure that the effect of vibration detection alarm.

6) Please note using the tracker away from water which can damage it. The tracker should be installed in a waterproof and good heat dissipation place. Do not plug any cable while the tracker is power on.

7) Turn off the tracker while replacing SIM card.8) After repeated use, the built-in battery may leaks or

bulge, its life is limited (about 1 year). So, regular check is preferred. In case of natural depreciation, please contact local dealer or manufacturer.

9) Be sure of the SIM card’s GPRS service is available.

7. Troubleshooting

Issues ResolvingInstructions don’t work

a) SIM card balance running lowResolving: Please recharge your count

b) SMS DelayResolving: Because of GSM network busy occasionally, SMS maybe blocked, please wait or try it later.

c) SIM card is not installed correctlyResolving: If SIM card indication

www.ttbvision.com

LED is flashing, please turn off the tracker and reinstall the SIM card. Please don’t do this while the tracker is on, otherwise, it may damage the tracker.

d) The tracker can not power onResolving: Check the power supply

Forgot password

Please call our telephone service; the service stuff will help you.

Change bound phone number

Use of another mobile phone sends SMS to the tracker: START, Current password, New password

Change tracker SIM card

First install the new SIM card and power on the tracker, then use the bound mobile phone to send SMS to the tracker with following format: START, Current password, New password, New phone number of tracker

www.ttbvision.com