FlameWheel550

User Manual V 1.0

www.dji-innovations.com

Disclaimer

Read this disclaimer carefully before using FlameWheel550. By using this product, you hereby agree to

this disclaimer and signify that you have read them fully. FlameWheel550 is an excellent multi-rotor. With

a good autopilot, it will even offer tremendous flight features for low altitude flight working in restricted

space. Despite the controller of autopilot operate in the safest manner when the main power battery is

connected, we strongly recommend customers to remove all propellers, use power supply from R/C

system or flight pack battery, and keep children away during system calibration and parameter setup.

Dajiang Innovation Technology Co. Ltd. assumes no liability for damage(s) or injuries incurred directly or

indirectly from the use of this product.

F550 Profile

FlameWheel550 (F550) is a multi-rotor designed for all pilots for fun or AP. With DJI WKM or NAZA

autopilot system, it can achieve hovering, cruising, even rolling and other flight elements. It can be

applied for entertainment, aerial photography, FPV and other aero-modeling activities.

Contents

Disclaimer .......................................................................................................................2

F550 Profile ....................................................................................................................2

Contents .........................................................................................................................3

Product Usage Cautions.................................................................................................3

In Box .............................................................................................................................4

Tools Needed .................................................................................................................5

Specifications .................................................................................................................7

ESC Wiring .....................................................................................................................5

Assembly ........................................................................................................................6

Product Usage Cautions

When flying, the fast rotating propellers of FlameWheel550 will cause serious damage and injury.

Therefore, please fly with a high safety consciousness.

1. Keep flying multi-rotor away from objects, such as obstacles, human beings, high-voltage lines and

so on.

2. Do not get close to or even touch the working motors and propellers, which will cause serious

injury.

3. Do not over load the multi-rotor.

4. Check whether the propellers and the motors are installed correctly and firmly before flight.

5. Make sure the rotation direction of each propeller is correct

6. Check whether all parts of multi-rotor are in good condition before flight. Do not fly with old or

broken parts.

7. Use DJI parts as much as possible.

If you have any problem you cannot solve during installation, please contact our customer service.

In Box

Top Board 550FBT ×1 Bottom Board 550FBB ×1

Arms 550FAC ×4 10in Propeller Pairs 550P10×4

Arms 550FAW ×2 8in Propeller Pairs 550P08×4

Motors 550MOT ×6 ESC 550ESC ×6

30AOPTO

+

-

U

V

W

Screws 550-M3×8 ×24 Screws 550-M2.5×5 ×36

Magic Strap 550MSX ×1, Battery Band 550BBX ×1

Tools Needed

2.0mm Hex Wrench For frame and motors installation.

Screw Glue For fastening screws.

Nylon Cable Tie

For binding devices and wires. Scissors

Diagonal Cutting Pliers

Foam Double Sided Adhesive Tape For fixing receiver, controller and other modules.

Soldering-iron & wires For connecting ESCs’ power cables to bottom board.

ESC Wiring

· Please solder ESCs to bottom board as the up figure shows. Use any insulating method at all soldering

spots.

· Make sure there is no short or open circuit.

· Make sure the side with bonding pads is upward.

ESC

To Battery

Power Pads

ESC ESC

ESC

ESC ESC

Assembly

① ②

③

④

Top Board

Bottom Board

Screws

M2.5×5

Screws

M3×8

⑤

⑥

Step 1Install bottom board

Step 2Install autopilot system

Step 3Install motors, ESCs

Step 4Install top board

Step 5Install propellers

· Install screws by appropriate force to prevent breaking threads.

· Use adequate screw g lue for installing screws.

· Please wire neatly. Make sure wires will not be cut by frame boards and propellers.

· Smooth out the boards edge if necessary

· Please install propellers after autopilot system configuration procedure.

· Make sure the rotation direction of propellers are the same as the figure shows

In up figure, arms ①② front of craft, arms ④⑤ are back of craft. See from top, motors on arms ①③⑤ rotate counter-clock wise, use propellers 8045; motors on arms ②④⑥ rotate clock wise, use propellers 8045R.

ESC Sound Introduction

ESC State Sound

Ready ♪1234567

Throttle stick is not at bottom BBBBBB…

Input signal abnormal B---------B---------B…

Input voltage abnormal BB----BB----BB----BB….

Tips:

DJI ESCs are specially designed for multi-rotors. When use with DJI autopilot systems, you do not

have to setup any parameters or calibrate travel range.

Specifications

Frame

Diagonal Wheelbase 550mm

Frame Weight 478g

Takeoff Weight 1200g ~ 2400g

ESC

Current 30A OPTO

Signal Frequency 30Hz ~ 450Hz

Battery 3S ~ 4S LiPo

Motor

Stator size 22×12mm

KV 920rpm/V

Propeller 10 × 4.5in (@3S with payloads)

8 × 4.5in (@4S without payloads)

FlameWheel 550

©2010-2011 Dajiang Innovation Technology Co. Ltd. All Rights Reserved.

6/F, HKUST SZ IER Building, No.9, Yuexing 1st Rd.,

South District, Hi-Tech Park, Shenzhen, 518057, Guangdong, China

Tel: 0086-755-2665-6677 Sales ext 201, 202, 203

Fax: +86-755-83067370 Service hotline: +86-755-22673777

Sales: sales@dji-innovations.com Technical support: support@dji-innovations.com

Others: info@dji-innovations.com

DJI FLAME WHEEL is registered trademark of Dajiang Innovation Technology Co. Ltd. Names of product, brand, etc.,

appearing in this manual are trademarks or registered trademarks of their respective owner companies. This product and

manual are copyrighted by Dajiang Innovation Technology Co. Ltd. with all rights reserved. No part of this product or

manual shall be reproduced in any form without the prior written consent or authorization of Dajiang Innovation

Technology Co. Ltd. No patent liability is assumed with respect to the use of the product or information contained herein.