ETX-5300A for TS2012 Slide 1 ETX-5300A Version 1.0

ETX-5300A for TS2012 Slide 1

ETX-5300AVersion 1.0


Why We Think ETX-5300A is a Winner

• Highest capacity-to-size ratio in the market• Best mechanisms for network efficiency• Reduce costs by freeing up PE capacity, cutting price per link• Complements RAD’s ecosystem• Warm reception by tier-1 carriers


ETX-5300A: Ethernet Aggregation + Pseudowire Gateway

17.3”

3U

14.9”

2 x Main Card, each supporting:• 4 x 10 GbE XFP (Max of 8)• 1+1 port or card redundancy

4 x I/O cards, each supporting:•20 x 1 GbE SFP/UTP (Max of 80)•2 x 10 GbE XFP (Max of 8)•4 x Ch. OC3 PWE3 (Max of 16)

Environment:• 0°C to 55°C

Timing:• IEEE 1588-2008: M,S & TC• Sync-E: External & Master• 1PPS, TOD & 10 MHz for phase

and frequency lock

Architecture:• E-line; E-Tree; E-LAN• OAM 802.1ag/Y.1731 per flow• Port redundancy (APS/LAG)• Ring G.8032 (2 x 10 GbE,

10 x 1GbE)

Chassis:• 3U Height• 4 I/O slots – 20 GbE slot• Redundant main switching

card with 4 x 10 GbE ports

Power Supply:• Redundant PSU AC/DC

Performance:• 200 GbE switch fabric• 100 GbE switching capacity


ETX-5300A Front View Description

4 x 10GbE XFP fully redundant

Alarm output connector

Fan Module

Secondary Main Card

Primary Main Card

20 x 1GbE Elec I/O card

20 x 1GbE Opt SFP I/O card

Air Filter

Redundant PSU (DC/AC Outlet)

Clocking Interfaces

Front View Access


Application Scenarios


Access Aggregation

1/10 GbE G.8032Rings

10 GbE

IP/MPLS

PE

1 GbE

10 GbE

1 GbE

ETX-2xx

ETX-2xx

ETX-5300A

ETX-220A

ETX-203AX

ETX-36

TDM

ETX-5300A

STM-1


Access Aggregation

• The service providers looking to cut the cost of a direct CPE/demark access connection to PE/router

• Target Customer:– Service providers – Alternative carrier – Wholesale providers – MSOs – Tier 1,2

• Solving the Problem:– reduce Capex by cutting the price per link in the

• Spectrum of Options:– Adva is the most direct competitor with similar capabilities using FSP-150EGX, we are about of the same

scale like the EGX but much smaller from factor and better power consumption. – Of course there are other competitors like Ciena that has smaller and bigger devices

Carriers that expanding their access & increasing

subscribers


ENNI

ENNI Application

Service ProviderNetwork

E-Access_A E-Access_BUNI

Subscriber Sites

UNI

UNI

Subscriber SitesOperator Network

ETX-5300A ETX-5300A

ETX-2xxA

ETX-2xxA

ETX-2xxA

UNI

UNI

UNI

ETX-2xxA

ETX-2xxA

ETX-2xxAHairpinning



ENNIE-Access_A E-Access_BUNI

UNI UNI

Carrier to Carrier Connectivity

• ETX-5300A Benefits for ENNI Application– Services: p2p and mp EVC types, single and multiple CoS per EVC– Multiple Shaped EVCs in Tunnels– Scalability: 1 and 10 Gbps PHYs– ENNI Protection: 2-link LAG, active/standby, LACP

Transit Model

Direct Connection Model

Subscriber Sites

UNI

ETX-2xxA

UNI

ETX-2xxA

ETX-2xxAUNI

ETX-2xxA

ETX-2xxA

Subscriber SitesETX-2xxA

Operator Network

ETX-5300A ETX-5300A


ENNIE-Access_A E-Access CUNI

UNI UNI

SubscriberSites

UNI

ETX-2xxA

UNI

ETX-2xxA

ETX-2xxAUNI

ETX-2xxA

ETX-2xxA

SubscriberSites

ETX-2xxA

Operator Network

ETX-5300A ETX-5300A

TransitNetwork

ENNIETX-5300A ETX-5300A

E-Access B


• Map SLA based services between two independent carriers

• Target Customer:

– Wholesale providers

– Carrier that has direct connection to another carrier

• Solving the Problem:

– maintain SLA and service characteristics between two carriers

– The device has to be conform to MEF 26/28 which most of the devices today do not support

• Spectrum of Options:

– there are many options to enable carrier to carrier connectivity as far as we know Adva and RAD are the

only vendors that support MEF26 for this purpose

Carrier that provides SLA based services to remote

subscribers

Carrier to Carrier Connectivity


Mobile Backhaul solution

IP/MPLS

PEPE

ETX-205AGbE

ETX-205A10 GbE10 GbE

RouterMME ETX-5300A

G.8032v2

ETX-5300A

RAD Access solution for Mobile1588 & SyncE Timing feeder

ETX-205A

ETX-205AETX-205A

GbE

ETX-5300A GM generates up to

512 x 1588 streams


• MBH super cell site or aggregation device near the AGW/RNC that also provides 1588 GM

• Target Customer:

– Wholesale providers

– MBO

• Solving the Problem:– Aggregates TDM & Ethernet into the transport network with timing capabilities, performs

local switching for x2 connection in LTE

• Spectrum of Options:– Many alternatives and solutions. – The unique selling point here is the combination of access aggregation, central demarcation

and timing generator in one box. – That will eliminate the use of 3 box solution

MBH Solution


Central Demarcation

The Need: • Ethernet Central Service Demarcation for Mobile backhauling • Requirement for Highly-scalable SLA monitoring & assurance

Solutions’ Benefits • Carrier-grade , fully redundant demarcation point• High scalability of Ethernet services and OAM sessions

IEEE802.1ag/Y.1731 OAM

Mobile Concentrator Wholesale

CarrierRouter

ETX

ETX

ETXETX

ETX

ETX-5300A 10 GbE NTU

RNC/aGW


Advantages of Having ETX-5300A with ETX-2xx

• Easy management integration of ETX-5300A along with ETX-20xA• Same MIBs as ETX-2xxA• Same CLI commands • Fully OAM interoperability between ETX-5300A and ETX-2xxA• Reduce certification process• Allows well optimized traffic engineering and network efficiency • Provides complete timing over packet solution

ETX-5300A

ETX-205A

ETX-220AETX-203AX

ETX-203AM


Thank You For Your Attention

www.rad.com

Documents

ETX-5300A for TS2012 Slide 1 ETX-5300A Version 1.0