Easter bracelet plans-how to make

bracelets with beads

Use some simple 10mm pearl beads and gauge wire from the craft store, you can rapidly learn how to make

bracelets with beads under half an hour, especially to create an fabulous and festival Easter bracelet.

Just in time for Easter. Make a significant vivid Easter

bracelet for yourself, your friend, families or anyone

other will love wearing handmade jewelry of a kind

of gift. While practicing by following this how to

make bracelets with beads plan, you will acquire

incredible customized Easter gifts and at meanwhile

go over the wire wrap techniques.

Stuff you’ll need in your Easter Bracelet:

10mm Acrylic Beads-Imitation Pearl

1mm Brass wire

Jumprings

Clasp

Side Cutting Plier

Round Nose Plier

Needle Nose Plier

Here’re details of how to make bracelets with beads:

Step1: make the fundamental

bead pattern

1. Snip about 12cm long wire and then slide

one 10mm pearl bead onto it;

2. Pull two wire ends crisscross over the

bead;

3. Bend one end to form a 90 degree;

4. Wrap the horizontal end around the vertical

one. Normally, 4 times is ok;

Step2: create the triangle pattern

1. Take out one more 12cm long wire and loop

one end for kind of Eyepin;

2. Slide on one 10mm pearl bead, the

fundamental bead pattern in step1 and then

one 10mm pearl bead;

3. Bend the wire into 90 degree;

4. Loop the other wire end and then process

the remaining wire in same way.

5. Remove the extra wire portion of wrapping

end;

6. Bend the vertical wire end outwards into a

90 degree again;

7. Create a loop at the bead top by Round

Nose Plier;

8. Wrap the remaining wire around 4 times

and finally trim off the sticking out wire

portion in same way.

At present, you crucial basic bead pattern for

the Easter bracelet has finished! Just repeat

the same processes for more of it.

5. Assemble each individual triangle bead

pattern for an Easter bracelet, just connect

the beginning and ending wire loops before

close them.

Step3: add on a closure for Easter bracelet

Once grouped all triangle clusters, attach the clasp

and Jumprings to two ends.

That’s it. Now you have obtained a new trinket around your wrist. Fell so proud of yourself?

However, that’s not enough. Just set your mind free and to branch out and try more bead

collocations you’d like to. Hope this how to make bracelets with beads institutions can help you

figure out more stunning and festival Easter bracelet, necklace, earrings……

For more stunning theme inspirations, please visit: www .pandahall.com/learning-center.html